Manualshelf

User's Manual Part 2

ManualsBrandsAngelcare Monitors ManualsBaby MonitorsBaby Monitor
12345678910
16.9 DO NOT attempt to recharge batteries
provided with or identified for use with this
product that are not intended to be charged. The
bat teries may leak corrosive electrolyte or expl ode.
16.10 D O NOT attempt to rejuvenate the batteries
provided with or identified for use with this
product by heating them. Sudden release of
battery electrolyte may occur, causing burns or
irritation to eyes or skin.
16.11 If and when necessary, the batteries must be
replaced with identical new ones or equivalent (volts
and size). If a battery to be replaced is connected
with other batteries in series, replace the other
batteries at the same time as well. DO NOT mix
old and new batteries.
16.12 Reverse polarity installation of the batteries
in the end product must be avoided. Reverse
insertion of batteries can cause charging, and
that may result in leakage or explosion.
16.13 Remove batteries from this product if you
store the product over 30 days because the
batteries could leak and damage the product.
16.14 Discard ‘dead’ batteries as soon as possible
since ‘dead’ batteries are more likely to leak in a
product. If a batter y has leake d or vented, it should
be replaced immediately using protective gloves.
16.15 DO NOT store this product, or the
batteries provided with or identified for
use with this product, in high-temperature
areas.
WARNING
(North America Only)
17. Modifications not authorized by the
manufactu rer may void use rs autho rity to ope rate
this device.
17.1 NOTE: This equipment has been tested and
foun d to comply with the limit s for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
17.2 H o w e v e r , t h e r e i s n o g u a r a n t e e t h a t i n t e r f e r e n c e
will not occur in a particular installation. If this
e qu ip m en t do e s c a us e ha r mf ul i nt er f er en c e t o ra di o
or television reception, which can be determined
by turning the equipment OFF and ON, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
17.3 This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
17.4 This device complies with the part 15 of the
FCC Rules and the Industry Canada license -
exempt RSS standards(s). Operation is subject
to the following two conditions:
17.5 (1) This device may not cause harmful
interference, and
17.6 (2) This device must accept any interference
received, including interference that may cause
undesired operation.
5
E
N
IC WARNING:
1.This device complies with Industry Canada
RSS standard(s). Operation is subject to
the following two conditions:
(1)this device must accept any interference,
and (2) this device must accept any inter-
ference including interference that may cause
undesired operation of the device.
2. Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.