User's Manual

5
Setting Up Your Monitor
Sensor Pad Sensor Pad
CORRECT
INCORRECT
CORRECT
Sensor Pad centered, colored side up
INCORRECT
Sensor Pad o center
INCORRECT
Sensor Pad colored side down
POSITION OF SENSOR PAD UNDER MATTRESS (Top down view of crib)
PLACEMENT OF SENSOR PAD CORD
Figure 1
Figure 2
SENSOR PAD (See figs. 1 and 2)
Place the Sensor Pad under the center of the crib mattress with the colored side facing up. Do not place any
loose bedding or linen between the crib mattress and the Sensor Pad. The Sensor Pad must rest on a flat, firm
surface. If your crib has a spring or slat base, place a piece of Masonite board under the Sensor Pad. This sup-
port must measure at least 13 inches long on all four sides and 1/4 inch thick. If your crib has a plywood base,
your mattress support is firm enough to use the monitor properly. Only use your Angelcare® monitor in a sta-
tionary sleeping environment such as a crib where the Sensor Pad can rest on a flat, firm surface. Be sure to
place the colored side of the Sensor Pad facing up. Now plug the Sensor Pad cord into the jack on the back of
the Nursery Unit marked “Sensor Pad”. Turn the Nursery Unit on using the switch on the left. The green Power
Indicator will light up. NOTE : The Sensor Pad works with all baby bed sizes and all mattresses, except memory
foam mattresses or mattresses with a hollow frame. You will need to test your Sensor Pad after the set-up is
completed.
CAUTION: To avoid potential strangulation accidents resulting from loose cords or wires in the crib, make sure
the Sensor Pad cord passes underneath the mattress entirely. After positioning the Sensor Pad under the mat-
tress, bring the cord to the corner of the crib and secure it to the top and bottom of the leg of the crib, or wind
it around the leg (see fig. 1).
SELECT YOUR DETECTION MODE
On the right of the Nursery Unit select one of the following three functions by moving the wing upwards or
downwards:
• Sound / Movement: You will be able to hear your baby's sounds and see sound lights. Your baby's
movements are monitored. If no movement is detected after 20 seconds, the alarm will sound.
• Tic Off: In this mode you will hear a “Tic” with every movement your baby makes. You will still hear your
baby's sounds and see sound lights, and your baby's movement is still being detected. If no
movement is detected, the “Tic” will stop and after 20 seconds the alarm will sound.
• Sound Only: The Movement Sensor is disabled but you will still be able to hear your baby's sounds and
see sound lights. Your Angelcare® works like a regular sound monitor when set to “Sound Only”.