User's Manual

TESTING THE SOUND FUNCTION

Switch the Nursery Unit to "Sound Only"

. Turn the Parents Unit ON and select either channel A, B or C. Make

sure it is set to the same channel as the Nursery Unit. The green power indicator LED will light up. Choose the

channel that gives you the best reception.

Test the sound: have someone else speak into the Nursery Unit or place a radio near the Nursery Unit. You

should hear sound from the Parents Unit. If there is no sound, refer to the Troubleshooting section.

Adjust the volume to the desired level using the slide button on the right of the Parents Unit.

TESTING THE BATTERY POWER

Verify that the units are operating on battery power by installing 3 AAA NiHM rechargeable batteries (included)

in the Parents Unit and 4 regular AAA batteries (included) in the Nursery Unit and unplugging the AC adapters.

The green Power Indicator should light up on all units.

Movement Sensitivity Adjustment

The movement sensitivity adjustment dial has been preset to a level which will suit most situa-

tions. The highest sensitivity level is 5 (most sensitive) and the lowest sensitivity level is 1 (least

sensitive).

You may get false alarms if your baby is in a very deep sleep or has moved to the edge of the crib. If you get

false alarms due to these circumstances, you should increase the sensitivity level by using the sensitivity dial

on the back of the Nursery Unit.

NOTE: Adjust the sensitivity level if you receive false alarms and you have followed the advice in the

Troubleshooting section for false alarms. Make a note of the position of the sensitivity dial before you change

it should you wish to return to that setting.

To increase the sensitivity level, start by increasing it by half a level. For example, if the level is currently at

2.5, increase it to 3. Use the monitor as you normally would. If you still experience false alarms, increase it by

another half level. If you are still experiencing false alarms when you have reached level 5, please consult our

customer service link on our website at www.angelcare-monitor.com

Because the Sensor Pad may detect movement from many sources from both inside and outside your baby’s

room, be sure all vibration sources are eliminated before changing the movement sensitivity level. Check to

see if the Sensor Pad is resting on a flat, firm surface. Place the crib near a solid supporting wall and away

from strong air currents. Do not use crib mobiles or accessories that may cause vibrations. Avoid contact with

the crib when monitor is in use.

To make sure you have avoided all external sources of vibration, take your baby out of the crib while the mon-

itor is on. If the alarm does not sound after you take your baby out of the crib, the sensitivity level may need

to be decreased. To decrease the sensitivity level, adjust by half a level by going from 2.5 to 2. If you are still

experiencing this problem when the level is set to 1, please consult our customer service link on our website

at www.angelcare-monitor.com

Movement Sensitivity adjustment