User's Manual

FALSE ALARMS

• Turn OFF the Nursery Unit.

• Verify the connection between Sensor Pad and Nursery Unit.

Unplug and reconnect the cord.

• Make sure there is no bedding between mattress and Sensor Pad.

• If the crib has a spring or slat base, place a hardboard between the crib base

and the Sensor Pad measuring at least 13” x 13” (33x33 cm) and 1/4” (6 mm) thick.

• Make sure Sensor Pad is positioned as described under the setup requirements.

Sensor Pad Sensitivity level may need to be adjusted, refer to step 5.1.

ALARM WILL NOT SOUND

• Avoid contact with the crib when the monitor is ON.

• Place crib near a solid supporting wall to avoid Sensor Pad from detecting movement

from outside the crib.

• You may need to decrease the sensitivity, refer to step 5.1.

• Turn OFF crib mobile, fans, loud music or anything else that may cause vibration.

NO SOUND IS BEING TRANSMITTED

• Ensure that both units are switched ON.

• If there is no power to any unit check/replace the batteries, recharge the Parent Unit

& check the AC Adaptors are working. Change electrical outlets if required.

• Check on the Parent Unit screen to see if the monitor is in MUTE mode instead of ON

mode. Refer to step 6.6. and increase volume level.

• Bring the Parent Unit and Nursery Unit closer together.

NURSERY UNIT POWER ON INDICATOR (GREEN LIGHT) DOES NOT LIGHT UP

• Check the connections or change to another electrical outlet.

• Push and hold the left ‘wing’ for 2 seconds to turn the Nursery Unit ON.

WEAK RECEPTION

• Bring the units closer together.

• Change the position of one or both units.

• Place the units on a ﬂat surface away from baby’s reach.

• Replace the batteries or recharge the Parent Unit.

STATIC, DISTORTION, INTERFERENCES

(FROM OTHER MONITORS, WIRELESS PHONES, WALKIE-TALKIES, ETC...)

• Rotate the Parent Unit or move it away from source of interference.

01mf5_manuel_NA_AC701_12002.indd 24 2013-12-19 1:36 PM