Instruction manual

PART 1 - GETTING TO KNOW YOUR MONITOR
FUNCTIONS PARENT UNIT
1. SensorPad
2. Power ON/OFF;
also EXIT function;
also MUTE function (Step 7)
3. ARROWS UP/DOWN (volume level);
also HOLD function
4. MENU button (to access menu);
also PAIRING & RECONNECTION button function
5. SELECT button (to confirm menu choices);
also CHANNEL button (to change transmission channel - Step 5)
6. Parent Unit display (shows all activated functions/settings)
7. Battery compartment
8. AC Adapter socket
9. Charging cradle
FUNCTIONS PARENT UNIT SCREEN
10. Temperature Indicator (in baby’s room)
11. Movement & Sound Monitoring Setting (Step 6, Menu 1)
12. Temperature Control Setting (Step 6, Menu 5)
13. Sound Transmission Setting (Step 6, Menu 3)
14. Out of Range Setting (Step 6, Menu 2)
15. Alarm Setting (Step 6, Menu 4)
16. Nursery Unit Icon (will flash if Parent and Nursery Units are not connected)
17. Parent Unit Icon (will be visible in MENU access only)
18. Battery Icon (will only be visible when batteries are inserted)
4
2
6
1
5
3
7
8
9
10
11
12
7
8
9
2
4
5
3
6
10
11
12
13
14
15
16 17 18
FUNCTIONS NURSERY UNIT
1. PAIRING/PAGING BUTTON
2. Power ON/OFF
3. Night light ON/OFF
4. PENDULUM light (flashes when movement is being detected)
5. POWER ON light
6. LOW BATTERY indicator
7. Microphone
8. Speaker
9. SensorPad socket
10. AC adapter socket
11. SensorPad sensitivity dial
12. Battery compartment
13. SensorPad
1. SensorPad: place the SensorPad under
the mattress in the middle of the baby’s
bed on a flat and rigid surface. Connect
the SensorPad to the Nursery Unit.
Keep the SensorPad wire out of reach
of the baby.
2. Nursery Unit: Insert 4 x AAA standard
batteries (not included) in the Nursery
Unit and connect the AC adapter to the
Nursery Unit and the mains. Check if
SensorPad sensitivity is on level 3.
3. Parent Unit: Insert 4 x AAA rechargeable
batteries (included) in the Parent Unit and
connect AC adapter to the Parent Unit
charger and mains. Place Parent Unit in
charger and charge for 15 hours.
4. Turn Parent Unit and Nursery Unit both
ON. Connection between the units should
establish automatically. If not, please go
to Part 2 - Step 4 in this Manual.
5. Test the SensorPad by putting your hand
on the mattress. The SensorPad should
detect your movements. Take your hand
off the mattress after approx. 60 seconds.
The alarm should sound after 20
seconds. Turn the Nursery Unit OFF to
stop the alarm. Repeat this process for all
four corners of the bed. Your Angelcare
Monitor is now ready for use.
Quick Set-up Guide
3
AC401
AC401 Deluxe
SENSORPAD
1