Instruction manual

8
Your monitor is ‘Sound Activated’.
This means that it will transmit
sounds only when it detects them.
It will detect even the softest levels
of crying.
The sensitivity of the microphone
is adjustable and has 4 levels.
The highest level (level 4) is the
most sensitive, i.e. it will activate
the sound transmission when the
lowest level of sound is detected.
To save power, after 10 seconds,
the sound transmission will stop
if no sound is detected. Once
sound is detected transmission will
automatically activate.
1. Press the MENU button briefly
three times.
2. The vertical bar on the left
hand side of the display will
show the actual microphone
sensitivity level. Standard
setting is a full vertical bar
(level 4).
3. Increase the microphone
sensitivity using the ARROW
UP and decrease the sensitivity
using the ARROW DOWN. A
higher sensitivity means that
the microphone will pick up
(softer) sounds quicker.
4. Press SELECT to confirm the
sensitivity level.
5. Press EXIT if you are finished
programming (or MENU if you
would like to go to MENU 4).
How to change
this setting
OVERVIEW ICONS IN DISPLAY:
Sound Transmission Indicator
Microphone sensitivity level
In MENU mode
Menu 3: Sound Transmission
FACTORY SETTING
The microphone sensitivity is set
to maximum sensitivity (level 4)
as standard, which means that
even the slightest sound will
activate the sound transmission.
Functions
The monitor is equipped with an
OUT OF RANGE Indicator function,
which will alert you when the
two units are not communicating
with each other. OUT OF RANGE
interference situations can be
caused by (e.g.) too much distance
or thick walls between the two
units.
RANGE
Up to 250 metres/820 ft (open
field); between 80 metres/262 ft
and 100 metres/328 ft (indoors).
When the units are OUT OF RANGE
you will hear a DOUBLE BEEP every
8 seconds and the OUT OF RANGE
icon (satellite dish) will flash on the
display of the Parent Unit.
When the alarm sounds move
the units closer together until
communication has been (re)
established.
OUT OF RANGE can also be used
to warn you to turn ON the Nursery
Unit again after you have taken
your baby out of bed (e.g.) for a
feed. If activated, the Parent Unit
will beep until the Nursery Unit is
turned ON again, or after 1 minute
the unit will switch itself off.
Functions
There are two options:
1. OUT OF RANGE OFF
2. OUT OF RANGE ON
Icons shown on display:
OF
ON
Options
1. Press the MENU button briefly
twice; the icons of the current
setting will appear (ON)
2. Select ON or OFF with the
ARROWS UP or DOWN
3. Press SELECT to confirm your
choice
4. Press EXIT if you are finished
programming (or MENU if you
would like to go to MENU 3)
How to change
this setting
OVERVIEW ICONS IN DISPLAY:
Out of Range indicator
In MENU mode
Sound level
Menu 2: Out of Range Setting
FACTORY SETTING
OUT OF RANGE is turned OFF