Instruction manual

9
There are 3 options to alert you when your monitor alarms:
Sound Alarm: An audible alarm will sound if an alarm is activated.
Vibrating Alarm: The Parent Unit will only vibrate if an alarm is activated,
no sound will be heard.
Sound & Vibration Alarm: Combination of a Sound and Vibrating alarm.
Functions
OVERVIEW ICONS IN DISPLAY:
Alarm Setting Indicator
Vibrating Alarm
Sound Alarm
In MENU mode
Sound level
Menu 4: Alarm Settings
FACTORY SETTING
Sound Alarm activated
1. Press the MENU button 4
times; the icons of the current
setting will appear.
2. Select your chosen
combination with the ARROWS
UP or DOWN (see 3 options
above).
3. Press SELECT to confirm your
choice.
4. Press EXIT if you are finished
programming (or MENU if you
would like to go to MENU 5).
How to change
this setting
There are three combinations:
1. Sound Alarm
2. Vibrating Alarm
3. Vibrating & Sound Alarm
Icons shown on display: Options
Menu 5: Temperature Control Settings
Your Angelcare Monitor can be
used to monitor the temperature
in your baby’s room and sound an
alarm if the temperature is either
too high or too low. A triple beep
will sound if the temperature is
outside the programmed range.
The temperature sensor in the
Nursery Unit is very sensitive
and readings can be affected
by (e.g.) cold or warm draughts,
placement next to a cold window
or above a heating radiator.
Always use a 2nd separate
digital thermometer placed in
a different part of the room to
achieve an accurate reading of
the temperature in the baby’s
room.
Functions
1. Press the MENU button briefly
five times; the icons of the
current setting will appear
(OFF).
2. Select ON or OFF (display will
show OFF) with the ARROWS
UP or DOWN.
3. Press SELECT to confirm your
choice.
4. If you have selected ON and
pressed SELECT, press
MENU to set the desired lowest
temperature level (snowflake
icon will appear) with the
ARROWS UP and DOWN. Press
SELECT to confirm your
setting.
5. Press MENU again to set the
desired highest temperature
level (sun icon will appear)
with the ARROWS UP and
DOWN. Press SELECT to
confirm your setting. Press
EXIT if you are finished
programming (or MENU if you
would like to go back to
MENU 1).
How to change
this setting
OVERVIEW ICONS IN DISPLAY:
Temperature Control Indicator
Low Temperature Setting
High Temperature Setting
In MENU mode
Sound level
There are two options:
1. Temperature Control OFF
2. Temperature Control ON
Icons shown on display:
OF
ON
Options
FACTORY SETTING
Temperature Control is OFF