PARTS LIST Ax2 Bx2 Left Armrest Dx4 Sway Bar Gx1 Table Cross Bar Jx2 Right Armrest Cx2 Back Cross Bar Ex1 Fx1 Front Support Bar (for Glass Table Top) Back Support Bar (for Glass Table Top) Hx1 Ix2 Glass Table Top Kx2 Le Leg Tube 02 HARDWARE LIST Right Leg Tube Chair Seat & Back Lx4 Chair Cross Bar Mx12 Nx4 M6x15mm Bolt Ox12 M6x35mm Bolt Px8 M6x45mm Bolt Qx16 M6x60mm Bolt M6x50mm Bolt Rx32 Tx8 Sx48 M6 Nut 5mm Plastic Washer Steel Washer Ux8 Vx4 8mm Plastic Washer 14mm Pl
Wx2 ASSEMBLY INSTRUCTIONS Xx2 STEP 1 : Place all chair parts on a protected flat surface. Assemble Sway Bar (D) to Left Leg Tube (J) with M6 x 45mm Bolt (O), 5mm Plastic Washer (T), Steel Washer (S) and M6 Nut (R). Do not tighten the bolt fully at this moment. Hex Wrench Open-end Wrench PREPARATION Repeat for right Leg Tube (K). Once it is done, repeat for another Sway Bar (D) at back. Next, assemble Back Cross Bar (C) to Right Leg Tube (K) using M6 X 15mm Bolt (M) and Steel Washer (S).
STEP 2 : Repeat STEP 1 for another chair. Mx4 Ox4 Sx8 STEP 3 : Assemble Chair Cross Bars(L) to Leg Tube (K or J) on the outside of chair seat using M6 x 60mm Bolts (Q), Steel Washers (S) and M6 Nuts (R). Do not tighten the bolts fully yet. See Figure 2. Repeat for another chair. Tx4 Rx4 S K R C S NOTE : DO NOT ASSEMBL E CHAIR CROSS BAR (L) TO LEG TUB ES ON THE INSIDE OF CHAIR SEAT UNTIL STEP 7 WHEN TABLE CROSS BAR (G) IS INSERTED INTO BOTH CHAIR CROSS BARS (L).
STEP 4 : Assemble Right Armrest (B) and Left Armrest (A) to Sway Bars (D) using ; M6 X 50mm Bolts (P), 8mm Plastic Washers (U), Steel Washers (S) and M6 Nuts (R). Do not tighten the bolts yet. See Figure 3. Repeat for another chair. Px8 Sx8 Ux8 STEP 5 : Put Glass Table Top (H) upside down on a protected flat surface. Assemble Front Support Bar (E) to the Glass Table Top (H) with M6* 15mm Bolt (M) .Repeat for Back Support Bar (F). See Figure 4.
STEP 7 : Connect glass table top to one chair by inserting Table Cross Bar (G) into Chair Cross Bars (L). Assemble Table Cross Bar (G), Chair Cross Bar (L) and Leg Tube (K or J) altogether using M6 x 60mm Bolts (Q), Steel Washer (S) and M6 Nuts (R). Do not fasten the bolts completely yet. See Figure 6. Repeat for another chair. Qx4 Sx4 STEP 8 : Assemble Chair Back (I) to Le Armrest (A) and Right Armrest (B) using M6 x 45mm Bolts (O), Steel Washers (S) and 14mm Plastic Washers (V). See Figure 7.
