Instructions / Assembly

Catania Fountain AD93711
We hope you will find these instructions helpful in setting up your product.
If you have any issues with this item, DO NOT return the unit to place of purchase.
Please visit our web site www.angelodecor.com for assistance and warranty information.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
This product must be dried and stored during freezing temperatures. Printed in China
Carefully align and
lower the bowl on to
the pedestal then
twist and lock the
large bowl to the
pedestal.
Install the cord pipe
cover over the cord
pipe as shown
above.
Set the pump housing
/ riser in to place, align
the grooves then twist
and lock it to the bowl.
Align, lower then
twist and lock the
small bowl to the
riser.
Attach the tubing to
the top.
Pass the tubing
through the centre of
the small bowl.
Lower and attach
the top to the small
bowl.
Locate the tubing
inside the pump
housing and attach
it to the pump.
inside the housing
and install the pump
access door.
The included 'shims'
can be used to level
the fountain if
needed.
Arrange all pieces in
your workspace.
Pass the power cord
down the cord pipe in
the large bowl.
Carefully rest the bowl
on its side. Feed the
pump cord down the
pedestal and out the
base.
Align the pump cord
with the groove at the
base of the pedestal.
couvercle du tuyau
sur le tuyau cordon
Dispose de tous les

Summary of content (5 pages)