User Manual

12 Combination Oven Installation and Operation Manual
Section 2
General Information
SAFETY DEVICES
Although the appliance is manufactured with all
safety devices, during installation and connection
additional devices must be added to comply with all
relevant federal, state and local code requirements.
WARNING
Make a daily check to
ensure all safety devices are properly
installed and in good working order.
Do not tamper with the safety devices in
the points sealed and marked with paint.
SAFETY AND INFORMATION LABELS
See “Safety Label and Sign Location” chart (located
on page 8) for the position of all safety labels
included on the appliance.
STANDARD ACCESSORIES
The appliance is delivered complete with the
following:
• Voltage conversion kit: for adapting the
appliance to the type of voltage to be used.
OPTIONAL ACCESSORIES
The appliance may be equipped with the following
accessories on request “see general catalog”.
ELECTRICAL LOCKOUT/TAGOUT
PROCEDURE
WARNING
Before performing any service
that involves electrical connection or
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
The Electrical LOCKOUT/TAGOUT Procedure is
used to protect personnel working on an electrical
appliance.
Before performing any maintenance or service that
requires exposure to electrical components, follow
these steps:
1. In electrical box, place appliance circuit breaker
into OFF position.
2. Place a lock or other device on the electrical
box cover to prevent someone from placing the
circuit breaker ON.
3. Place a tag on electrical box cover to indicate
that appliance has been disconnected for
service and power should not be restored until
tag is removed by maintenance personnel.
4. Disconnect the appliance power cord from the
electrical outlet.
5. Place a tag on the cord to indicate that unit has
been disconnected for service and power should
not be restored until tag is removed.