User Manual

Combination Oven Installation and Operation Manual 87
Section 8
Troubleshooting
TROUBLESHOOTING
The appliance has been tested before being put into
service.
The information provided below is intended to assist
in the identifi cation and correction of any irregularities
and malfunctions which might occur during use.
The user can solve some of these problems on their
own, but in most cases specifi c technical knowledge
or skill is required. More advanced troubleshooting
may need to be done by an authorized service agent.
ALARM IDENTIFICATION
If the problem or fault noticed is not among those
listed in the table, consult the “Key to Alarms”
table.
The information provided is intended to identify the
alarm signals which appear on display (A).
IMPORTANT _________________________
Press button (D) to reset the alarm.
Fault Cause Remedy
The appliance does not
switch on
Fuse “blown” Replace the fuse (see page 85)
Safety or protection device (safety
thermostat or overload cutout) tripped
Press device reset button
Electronic circuit board damaged Contact an authorized service agent
Cooking cycle does not
start or stops suddenly
Control board electronic circuit board
damaged
Contact an authorized service agent
Alarm triggered Consult the “Key to Alarms” table
The cleaning cycle
does not start or stops
suddenly
Control board electronic circuit board
damaged
Contact an authorized service agent
Alarm triggered Consult the “Key to Alarms” table
D
A