User Manual

88 Combination Oven Installation and Operation Manual
Section 8
Troubleshooting
KEY TO ALARM TABLE
Alarm Fault Remedy Notes
H2O No water in chamber, or
water pressure too low
Check that mains water is
present or adjust the pressure
(see page 23); if the problem
persists call an authorized
service agent
Convection cooking cycles can still
be performed
H2O. No water at drain, or water
pressure too low
Check that water supply is
present or adjust the pressure
(see page 23); if the problem
persists call an authorized
service agent
Convection and steam cooking
cycles can still be performed
OPE Oven door opening or
closure request
Open or close the oven
door, Call an authorized
service agent if this message
continues to be displayed
The cooking cycle does not start
until the door has been opened or
closed as required
CLE Indicates that cleaning is
required
Launch an automatic cleaning
cycle
The oven’s functions are enabled;
cooking cycles can be performed
dEC Indicates the need for the
descaling operation
Perform descaling The oven’s functions are enabled
so cooking cycles can be carried
out
E01 The cooking chamber probe
has failed or is not properly
connected
Call an authorized service
agent
The oven’s functions are disabled;
no cooking cycles can be
performed
E02 The core probe has a failure
or has not been properly
connected
Check the position of the
product core probe or call an
authorized service agent if it is
faulty
Cooking cycles with product core
probe cannot be performed
E03 The steam discharge probe
has failed
Call an authorized service
agent
Convection and steam cooking
cycles can still be performed
E04 The motor-operated valve is
not positioned correctly
Switch on the oven again and
if the problem persists call an
authorized service agent
Convection and steam cooking
cycles can still be performed
E05 Safety thermostat failure Call an authorized service
agent
The oven’s functions are disabled;
no cooking cycles can be
performed
E06 Overload cutouts tripped Call an authorized service
agent
The oven’s functions are disabled;
no cooking cycles can be
performed
E07 Power board failure Call an authorized service
agent
The oven’s functions are disabled;
no cooking cycles can be
performed
E08 The optional vacuum probe
has failed or is not properly
connected
Press the “Reset” button Disconnect and reconnect the
vacuum probe before starting
the cooking cycle. If the problem
persists, call an authorized service
agent