User Manual

Combination Oven Installation and Operation Manual 89
Section 8
Troubleshooting
KEY TO ALARM TABLE (Continued)
Alarm Fault Remedy Notes
E09 Maximum allowed
temperature in chamber
exceeded
Contact an authorized service agent The oven’s functions are
disabled so no cooking
cycles can be carried out
E10 Electrical component
compartment has
overheated
The oven solves the problem on its own The oven’s functions are
enabled; cooking cycles
can be performed
E11
E13
E14
Electronic circuit board
diagnostics tripped
Call an authorized service agent The oven’s functions are
enabled; cooking cycles
can be performed
E19 The humidity probe has
failed or is not properly
connected
Call an authorized service agent The oven’s functions are
enabled; cooking cycles
can be performed
E20 Setup error Call an authorized service agent The oven’s functions
are disabled; no cooking
cycles can be performed
E21 The washing cycle
has been interrupted
because there is no
cleaner
Check the pipe position and the level of
cleaner in the tank; top up if necessary and
restart the washing cycle.
If it is not possible to complete the cleaning
operation, perform an emergency rinse or
rinse the cooking chamber by hand
If the problem persists,
call an authorized service
agent
E22 The washing cycle
has been interrupted
because there is no
sanitizing cleaner
Check the pipe position and the level of
sanitizing cleaner in the tank; top up if
necessary and restart the washing cycle.
If it is not possible to complete the cleaning
operation, perform an emergency rinse or
rinse the cooking chamber by hand
If the problem persists,
call an authorized service
agent
E23 The washing cycle has
been interrupted during
the fi nal sanitization
stage
Press the reset button and rinse the cooking
chamber thoroughly by hand.
Operate the oven in convection mode to dry
the cooking chamber.
If the problem persists,
call an authorized service
agent
E24
E26
Automatic cleaning
system failure
Check that no residues of cleaning products
have been left inside the cooking chamber.
Rinse the cooking chamber by hand.
If the problem persists,
call an authorized service
agent
The oven’s functions
are enabled so cooking
cycles can be performed
E25 System fi lling procedure
not completed
Check the position of the pipe and the level
of the sanitizer in the container; if necessary,
top it up and re-launch the automatic
cleaning cycle.
If the problem persists,
call an authorized service
agent