User Manual

Product Description
Technical Specifications
Nominal Speeds
Speed Variance
Wow and Flutter
Signal to Noise
Down force Range
Effective Tonearm Length
Overhang
Power Consumption
Outboard Power Supply
Dimensions (W x H x D)
Weight
Technical Specifications
Frequency response
Recommended load resistance
Channel balance
Amplifier connection
Channel separation
Recommended tracking force
Output voltage
Weight
33 1/3 & 45RPM
±1%
≤0.15%
55dB
3.0-6.0g
8.6” (218.5mm)
0.73in
5W (Max)
12V/500mA AC-DC
420 x 360 x 125mm
5.7kgs
AT-3600L (audio-technica)
20Hz-20kHz
47kohms
<2.5dB
MM - input
>18dB
3.5±0.5g
2.5mV
5g
Installation
1-Installing the Lid
2-Turntable platter and belt setup
Install the Lid carefully over the hinge prongs
- Unpack all parts and remove protective material.
- Do not connect the unit to the mains before checking the mains voltage and before
all other connections have been made.
- Those instructions are related only to products using power cable or AC power
adaptor.
1. Insert the sub-platter into the turntable spindle located in the middle of the
turntable.
2. Loop the drive belt around the sub-platter and motor pulley.
3. Carefully place the main platter onto the sub-platter (Figure 1).
4. Place the slip mat on top of the platter (Figure 2)
33 RPM 45
- Figure 1 - - Figure 2 -
33 RPM 45
- 6 - - 7 -