User Manual

Installation Installation
3-Cartridge tracking force adjustment
- Gently push and turn the Counterweight onto
the rear of the tonearm (with the scale facing
toward the front of the turntable).
- Remove the cartridge protection cap.
- Lower the tonearm lift and position the
cartridge in the space between tonearm rest
and platter.
The counterweight supplied is suitable for cartridges weighing between 3.0-6.0g
Carefully rotate the Counterweight until the tonearm balances out. The tonearm
should return to the balanced position if it is moved up or down.
This adjustment must be done carefully.
Once the tonearm is correctly balanced return it to its’ rest. Hold the Counterweight
without moving it, and gently rotate the Down force Scale ring until the zero is in line
with black line on the rear of the tonearm. Check whether the arm still balances out.
Rotate the counterweight counter clockwise (seen from the front) to adjust the
down force according to the cartridge manufacturer’s recommendations.One mark
on the scale represents 0.05g of down force.
3-Cartridge tracking force adjustment
Note: The recommended down force for the factory fitted cartridge is 3.5±0.5g.
Counterweight
Tracking Force Dial
Center Line
4-Anti-skating force adjustment
The anti-skating force must be adjusted corresponding to the tracking force as follows:
1. Slip the loop of the anti-skating weight's
thread over the 3rd groove of the stub to
set the correct anti-skating force for the
factory-fitted cartridge.
2.Feed the thread through the loop of the
wire support.
- 8 - - 9 -