Manualshelf

User Manual

ManualsBrandsANGELS HORN ManualsElectronicsTurntable, Vinyl Record Player, Built-in Phono Preamp Belt Drive 2-Speed, Adjustable Counterweight, (Mahogany Wood)
12345678
Installation
This turntable uses a moving magnetic cartridge. Set the PHONO & Line Out Switch
on PHONO mode.
Connect the phono out cables to the phono input on your amplifier of the pre-ampli-
fier (phono stage). Line inputs such as CD, Tuner, Tape, or Video are not suitable for
phono inputs. Make sure the amplification of the selected input matches the type of
cartridge being used.
The factory-installed cartridge is 47k ohms/MM-input.
Set the PHONO & Line Out Switch on LINE mode. The RCA PHONO & Line Out
Jacks output analog line-level signals and could be connected directly with a par of
active/powered speakers of the appropriate input of your stereo system.
The Red plug connects with the Right channel and the White plug connects with the
Left channel.
5-Connection to the Amplifier
6-Stereo System Connection
NOTE: If your amplifier does not have an input suitable for phono cartridges, you will need
to purchase a separate phono amplifier for moving magnetic cartridges. This separate phono
amplifier will then connect between your turntable and your amplifier.
NOTE: The RCA Jacks are not designed to be connected directly to the passive/unpowered
speakers on LINE mode. If connected to the passive speakers, there is no sound
Installation
Operation
7-Main Power Connection
Turntable Operation
The power adaptor is in the foam packing material. Unpack the power adaptor and
plug the small end into the DC power jack located at the back side of the turntable.
Plug the power adaptor into your power outlet.
1. Connect the included power adapter to the unit and press the power rocker switch
to be “ON” position.
2. Remove the needle cover from the cartridge.
3. Place the slipmat on the platter and place a record on the slipmat. If using 45 RPM
records, but the 45 RPM adapter on the center spindle before placing the record
on the platter.
4. Set the 33/45 RPM Selector according to the type of record.
5. Unlock the arm clip and set the Lift Lever to the up position.
6. Position the tonearm over the desired location (groove) on the record. The platter
will begin spinning.
7. Move the tonearm lift lever to the down position to move the tonearm toward the
record. Alternatively, place the needle over the desired location on the record.
8. Carefully lower the tonearm on the record.
9. When you are finished playing the record, raise the tonearm, return it to rest on
the arm clip.
Protector
Active Speaker
Amplifier
- 10 - - 11 -