User Manual

Troubleshooting

Potential Incorrect Use and Fault Conditions：

Problem

The platter doesn’t turn

although the unit is

switched on

No signal through one or other

channel or both channels:

Strong hum on phono input:

Distorted of inconsistent sound

from one or both channels:

Solution

These turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory.

Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by

incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included.

- The unit is not connected to the main power supply.

- No power at the outlet.

- Drive belt is not installed or has slipped off.

- The unit automatically switched in standby mode, power OFF and ON again on

the backside.

- Phone input not selected at the ampliﬁer.

- Ampliﬁer not switched on.

- Ampliﬁer or speakers muted.

- No connection to the speakers.

- No connection between turntable and ampliﬁer.

- Wire leads not connected to the cartridge.

- No ground connection from the cartridge, arm, or arm cable to ampliﬁer or

ground loop.

- Turntable too close to speakers.

- Turntable is connected to the wrong input of the ampliﬁer.

- Needle or cantilever damaged.

- Drive belt overstretched or dirty.

- Platter bearing without oil, dirty or damaged.

- Dust on the stylus.

- MM/MC switch on the pre-ampliﬁer set incorrectly.

Angels Horn Corporation

44 W JEFRYN BLVD, SUITE V, DEER PARK, NY,11729 U.S.A

Email: info@angelshorn.com

Website:www.angelshorn.com

Ver.1 2019.11.04 162501372-02-02

Ver.2 2019.11.04

- 14 -