User`s manual
GENERAL INFORMATION
3
Peripheral Descriptions
A. Power indicator - A red indicator LED signies that power is connected.
B. Audio - Connector is 3.5mm female phono jack. Sends a normal high-Z computer
level audio signal, therefore it must be connected to a high-Z input device (ie stereo
receiver, fm transmitter, certain high-Z inputs on a mixing board). The device cannot be
directly connected to a power amplier or other low-Z device.
C. Indicator LEDs (1 - 6) -
- Play - ON - Signies a show is currently playing
- MP3 - ON - Signies that an MP3 is currently playing
- DMX - ON - Signies that a DMX le is currently playing
- HB - Slow ash (~1sec) - signies “OK” working status of unit
- SD - OFF - Signies “OK” SD card
- IP - Generally OFF - Pulses the IP address digits at startup
D. Port 1 - This is commonly the ACL port. Connect your standard light controllers
(LC-16) to this port.
E. Port 2 - This is commonly the XDMX port. Connect your Pixel Driver to this port. Up to
2 pixel drivers can be connected.
F. Terminator - Place a jumper on these two pins if you experience “shaky” looking light
shows or light shows that appear to icker and strobe in a way that is unintended.
G. Ethernet Connector - Plug your MB into your internet router for a minimum of 3
hours to automatically update the time.
H. Power Input - Connects to the provided 7 to 24Vdc power adapter. Connecting power to
the MBx32 is the very last step in setting up your system.
I. Micro USB Connector - Reserved USB connectivity
J. SD Card Slot - Insert show card here. Push card all the way into the slot until it “clicks”
and remains ush with the enclosure.
K. SD Card Indicator - What does this do?