Specifications

03/04
ComBi
line
68
6.1.2 Timer function
The appliance comes with a built-in timer clock as standard.
You can use this to start a coffee brewing process and/or hot
water system at a certain time.
1. Press the timer button (fig.. 1-6.9). The following
possible settings (fig. 9A) appear in the display.
2. Select the system you want to switch on automatically.
Use the selection arrows for this. Tap = hot water
system. Container = coffee brewing system. Confirm
your selection with the START button .
3. Set the required start time (day/hour/min) with the left
and right selection buttons (fig. 9B) and confirm your
setting with the START button . The day automatically
moves to the next day when the hour setting goes past
24:00. Confirm your choice with the START button .
4. Select the required brewing quantity (fig. 9C) and
confirm your choice with the START button (fig. 9D)
appears in the display.
5. Place a basket filter paper in the basket filter and fill it
with the recommended brewing amount of coffee
(standard ground) as shown in the display. Spread the
coffee evenly in the filter and put the filter lid on. Then
place the filter unit on the container, and position the
swivel arm above the centre of the filter.
Tip: check if the container is empty. Confirm your choice
with the START button .
6. Explanation of the display (fig. 9E):
Clock symbol (flashing): timer clock is activated
The brewing quantity, start time and day are displayed.
Swivel arm/container symbol: The coffee maker is ready.
Tap symbol: The hot water system is ready.
7. The appliance may NOT be switched off!
Tip
- The timer clock function can only be cancelled by
pressing the STOP button .
- The container heating switches on automatically 5
minutes before the set time (pre-heating).
- The coffee brewing process and hot water system is
switched off during an activated timer clock function.
The container heating can be used normally, for
example, to keep the coffee on the left warm, while on
the right the coffee brewing process is pre-programmed.
- The timer can be programmed a maximum of 6 days in
advance. This enables you to bridge a long weekend
easily.
- The swivel arm and container safety devices remain
active. If the swivel arm moves out of position, for
example, it is detected immediately and a warning
symbol appears in the display followed by a beeping
sound (2x short). Once the swivel arm is moved back to
the correct position, the timer clock is active again.
Timer display Fig. 9