Specifications

03/04
ComBi
line
72
7.1.5 Cleaning the gauge glass
1. Empty the container, remove the filter and the coffee
blender.
2. Take the gauge glass lid (fig. 14A) off by pulling it
vertically up from the protector profile.
3. Take a dry cloth, and use it to take the top of the gauge
glass (fig. 14C) from the recess and pull the gauge glass
carefully diagonally up out of and loose from the tap
connection.
4. Remove the bottom tulle (fig. 14F) from the gauge glass
and clean the gauge glass with the help of the supplied
gauge glass brush. (careful fragile!)
5. Moisten the gauge glass ends + tulle and put the tulle
back in the glass and push the gauge glass into the tap
connection with the tulle (fig. 14G).
6. Always put the gauge glass lid (fig. 14A) vertically on the
protector profile, push the top tulle with the index finger
(in the middle of the gauge glass lid).
Please note: make sure that the gauge glass lid stays
firmly pushed against the container wall when placing it.
Only then the gauge glass will stay well. (The lip in the
gauge glass lid (fig. 14A) must be behind the holding
plate (fig. 14B).
Tip: On the inside of the gauge glass protector is a spare
gauge glass (fig. 14D). The assembly of the gauge glass
system is much easier if you moisten the gauge glass ends
and tulles well.
figure 14
A - Gauge glass lid
B - Holding plate
C - Gauge glass
D - Extra gauge glass
E - Protector profile
F - Lower tulle
G - Tap cap
G
F
E
D
C
B
A
1
3
2
Cleaning gauge glass Fig. 14
WARNING
• Risk of burning! Empty the container before you remove
the gauge glass for cleaning.
• Always treat the gauge glass with the necessary caution.
Take the glass out of the protector with the help of a dry
cloth and hold the gauge glass firmly with the cloth as
you clean it with the gauge glass brush.