Rechargeable Hand - Stick Vac For Household Use Only Model No.: VC101 Item No.: 42610700 Rev 2 Note: The specifications and/or components of this appliance are subject to change without prior notice. If any Accessories should fail during use, please call 1800 079 124 for an immediate replacement. This will save you from returning the product to the store.
1 2 3 4 5 Warnings .................................................................................. 3 Safety Directions ..................................................................... 3 Transporting your Vacuum .................................................... 6 Components ............................................................................ 6 Assembly Method ................................................................... 7 5.1 5.2 5.3 5.4 5.5 5.
1 Warnings Before using this appliance, read and follow all warnings and instructions in this manual, even if you are familiar with this product. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
DO NOT misuse the Charger Cable. Never pull the appliance by the cable or pull to disconnect it from the outlet. Instead, grasp the charger body and pull to disconnect. DO NOT use the vacuum cleaner to pick up large objects, hard or sharp objects such as glass, nails, screws, coins, etc. that are likely to cause damage. DO NOT use with damaged Charger Cable or Charger Body. DO NOT use vacuum cleaner if it has been dropped, damaged, left outdoors, or dropped into liquid (water etc.
DO operate the Charger from a power source of the same voltage, frequency and rating as indicated on the product identification plate. WARNING Only use the Battery Charger which was supplied with this appliance. Model No. ZD12D260050AU 100 – 240V~ 50/60Hz 0.5A Output: 26.0V 500mA Battery Pack Specification: Type: Li-ion x 6 cell, 22.2Vd.c., 2200mAh, 48.48Wh Consumers are cautioned against using and/or purchasing counterfeit and/or inferior quality batteries.
Read and Save These Instructions 3 Transporting your Vacuum To move your vacuum cleaner from room to room, unplug the unit and carry using the carry handle. Never pull or carry the vacuum cleaner by its Charger cable. Never carry the vacuum cleaner by the accessories / Tools.
5 Assembly Method Please Note: Always remove the Battery Charger from the power socket before assembly. 5.1 Assembling the Extension Tube Insert the end of the Extension Tube into the mating hole ensuring the locking tab is aligned, then push inward until it locks into place. 5.2 Removing the Extension Tube To remove the Extension Tube, grasp the Tube, press the locking tab down to release then pull the hose straight out. 5.
5.4 Removing the Motorised Floor Head To remove the Motorised Floor Head, grasp the Tube, press the locking tab down to release, then pull the Motorised Floor Head straight out. 5.5 Using Without the Extension Tube. The vacuum cleaner can be used without the extension tube by attaching the Accessories and Motorised Floor Head directly to the vacuum cleaner. To attached and remove, follow the same steps as if using the Extension tube. 5.
Brush Tool Brush attachment can be used for general applications The Brush Tool head can be rotated to your desired angle. Grasp the tube end and twist the head. To fit the tools, line up with the end of the hand vac and push in. Note: The tools can also be used on the end of the Extension Tube. To remove, press the locking tab down to release and then pull the attachment straight out.
Tool Holder. The tools can be stored on the Extension Tube as Shown. Note: To attach the Tool Holder, a Philips Head Screwdriver will be required. Remove the screw from the tool holder first. Spread open the Tool Holder enough to fit over and around the Extension tube. Note: Ensure the “Hump” is aligned with the Rib of the Extension Tube. Refit the screw and tighten.
Attach the Tools by clipping them into place. 6 Charging Note: Charge the Vacuum Cleaner for at least 5 hours prior to use. Only use the Battery Charger which was supplied with this appliance. Insert the battery into the bottom of the vacuum Cleaner body and push all the way in until it locks in place. Note: The Battery can only be inserted in one direction as shown To Remove the battery, press the release button located underneath the vacuum cleaner, and the battery will be released.
With the Battery Charger unplugged from the power point, plug the small pin plug into the side of the Battery as shown. Plug the Battery Charger into the power point and switch on. During Charging, the indicator light will glow Red. When the battery is fully charged, the indicator light will glow Green. Switch off and unplug the battery charger from the power supply. Remove the small pin plug of the battery charger from the vacuum cleaner. When fully charged, the Vacuum Cleaner is ready for use.
7 Using the Vacuum Cleaner To use the Vacuum Cleaner, assemble the unit as previously instructed and ensure the battery is fully charged. The fully charged battery should provide 15 - 20 minutes of power for continuous use of the vacuum cleaner. Pull the Handle Trigger once to turn on the vacuum cleaner in low power mode, twice for high power. Pull the trigger again to turn Off. There are three indicator lights on the top of the vacuum cleaner indicating the state of charge.
Take the dust canister to a dustbin. Press the Trap Door release button inward to release the latch and the trap door will swing open emptying the contents into the bin. To close the trap door, close it manually until it clips shut. Empty the Dust Canister as frequently as possible or when the suction power is reduced or after use for optimum performance. Note: At the same time, you can brush the inside of the dust canister with a small brush or use water to wash Refer to section “Cleaning the Filter”.
9.1 Cleaning the Filter Important Note – The Filter must be cleaned regularly for the best suction performance and to prevent over-heating and damage to your vacuum cleaner. Cleaning is best done at the same time when emptying the dust Canister after you have finish vacuuming for the day. NOTE: Never use the vacuum cleaner with a wet or damp filter or without the filter fitted. Using a wet or damp filter will damage the filter, may cause serious damage to the vacuum cleaner and will void your warranty.
Wash the filter in warm mild soapy water, rinse in clean fresh cold water and let completely dry. DO NOT scrub the filter or place in a dishwasher. DO NOT use a hair drier to dry the filter. Refit the Filter (or replace with a new one) in the reverse method used for disassembly. When refitting the lid, there are markings on the Lid and Dust Canister which need to be aligned. When aligned, push the lid down and rotate clockwise until the markings show the lid is locked as shown. 9.
DO NOT use a hair dryer to dry. Use a dry cloth or paper towel. Refit the components in the reverse method used for disassembly. IMPORTANT: The inner component must be fitted in a certain position. There are three location tabs which must be aligned in their corresponding slots as shown. Small Tab Large Tab Small Tab 9.3 Cleaning the Vacuum Cleaner Body and Tools Do not clean the vacuum cleaner, components or accessories using petrol or any other flammable liquid or solvents, etc.
There is a small locking plate on the right side which needs to be pushed over to the right. Grasp the brush und pull straight out After Cleaning the brush, refit and slide the locking plate back over to the left to secure the brush. 10 Storage When finished using the vacuum cleaner, either recharge the battery first, or store it away in a dry cool place. 10.1 Wall Mount There is a wall hanging mount supplied with screws and wall plugs if you prefer to hang the vacuum cleaner on the wall.
Hang the vacuum cleaner as shown 11 Troubleshooting Will Not Switch On Check that the Battery is fully charged. Red Light on Battery is showing when Charging This is correct. It will turn Green when fully charged. Only 1 or 2 Blue Indicator Lights on Top are on. This is correct. All 3 lights will be on when the battery is fully charged. 2 lights when half charge, 1 light on when battery is running low.
12 Warranty Against Defect 12 Month Warranty Thank you for your purchase from Kmart. Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where provided. This warranty is in addition to your rights under the Australian Consumer Law.
