User Manual

Page 18 of 20
There is a small locking plate on the right side which needs to be pushed
over to the right.
Grasp the brush und pull straight out
After Cleaning the brush, refit and slide
the locking plate back over to the left to
secure the brush.
10 Storage
When finished using the vacuum cleaner, either recharge the battery first,
or store it away in a dry cool place.
10.1 Wall Mount
There is a wall hanging mount supplied with screws
and wall plugs if you prefer to hang the vacuum cleaner
on the wall.
To install the hanging mount position the hanging mount on the wall and
at a suitable height where the vacuum cleaner will not touch the floor.
Mark the three screw holes through onto the wall.
Using a suitable drill (wood drill bit for timber wall, or masonry drill bit for
brick / concrete walls, drill three holes Ø6mm and 35 - 40mm deep.
Insert the plastic wall plugs into each hole and gently hammer in until they
are flush with the wall, place the hanging mount over the holes then insert
the screws and tighten up. Do Not Overtighten.