Operator’s Manual ANKOMRD Dryer (RD, RDI) 2052 O’Neil Rd Macedon NY 14502 Telephone: (315) 986-8090 · Fax: (315) 986-8091 www.ankom.
TABLE OF CONTENTS Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Safety Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Instrument Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Instrument Setup and Installation. . . . . . . . . . . . . . . . . . . . . .6 Operating Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7 Periodic Maintenance. . . . . . . . . . .
WARRANTY RD ANKOM Technology Corporation warrants the ANKOM Dryer against any defects due to faulty workmanship or material for a one-year period after the original date of consumer purchase. This warranty does not include damage to the instrument resulting from neglect or misuse. If the instrument is damaged as a result of defects in the workmanship or materials during the warranty, ANKOM will repair or replace the instrument free of charge.
Safety Precautions ANKOM DryerRD Caution: Hot Surfaces - Do not touch the cabinet during operation. The surface can exceed 70o C (158o F). Failure to observe this caution may result in injury. Caution: Hazardous Voltages- Do not operate the instrument with the electrical compartment open. Hazardous voltages are present during operation. Electrical shock or electrocution may result if ignored.
Instrument Description Filter Power Switch Temperature Controller Filter Latch Fuse Holder (2) Power Receptacle Air Inlet The ANKOMRD Dryer is designed to remove moisture from ANKOM XT4 or F57 filter bags. Simply place filter bags in the bag holder with clip-on handle in place and set the holder in the drying chamber. Attach a filter to the top of the drying chamber and press the power switch which turns on the heat and fans to dry the samples.
Instrument Set Up and Installation Requirements: Tools: Flat blade screwdriver Power: 100-120V 50-60 Hz (domestic) 220V-240 50-60 Hz (int’l) The ANKOMRD Dryer should be installed in a vent hood free of dust and excessive moisture. The ANKOMRD power cord must use a grounded receptacle. Hydrolysis leaves small amounts of HCl in the filter bags even after rinsing.
Operating Instructions Sample Drying Follow the sample drying protocol in each specific procedure. Blotting reduces drying time for hydrolysis samples. After completion of hydrolysis, the filter bags are blotted on paper towels. Place the wet samples on four sheets of paper towel. Place two sheets on top of the bags. Uniform pressure (ANKOM Blotter or similar) is used on top of the paper towels to gently press the water out of the bags. ANKOM Blotter (part #H35) is foam cushioned and weighs ~10 lbs.
Periodic Maintenance Wipe the outside of the instrument with window cleaner or a damp sponge as necessary. Do not use Acetone. Fuse Replacement- Turn off the power and unplug the instrument. 1. Use a screwdriver to twist (counterclockwise) the gray fuse holder. Remove the holder and replace the fuse. 2. Push in and twist (clockwise) to install the new fuse. Filter ReplacementThe RD2 HCl filter should be replaced when the maroon bottom filter media of the filter degrades or sags below the filter frame.