User's Manual

NaviCam Small Bowel Capsule Endoscopy System
User Manual P a g e |
94
ANKON Technologies Co., Ltd. AKQWO-YF-018 Rev A/1
10.5.3 Locator
Guid ance an d m an ufa c tur e r ’s d ec laratio n - e l ect r on i c e missi ons
The Locator is intended for use in the electromagnetic environment specified below.
The user of the Locator should assure that it is used in such anenvironment.
Emissions
test
Compliance Electromagnetic environment - guidance
Radiated
emissions CISPR
11
Group 1 The Locator uses RF energy only for its internal
function. Therefore, its RF emissions are very
low and are not likely to cause any interference
in nearby electronic equipment.
Conducted
emissions CISPR
11
Class A
Harmonic
Emissions IEC
61000-3-2
N/A
The harmonic current test and The voltage
fluctuation
and flick test are not necessary because the Locator isn’
t
intended to be connected to the PUBLIC
MAINS
NETWORK.
Voltage
fluctuations and
flicker emissions
IEC 61000-3-3
N/A
Guidance and manufacturer’s declaration - electromagneticimmunity
The Locator is intended for use in the electromagnetic environment specified below.
The user of the Locator should assure that it is used in such anenvironment.
Immunity test IEC 60601 test level Compliance level
Electromagnetic
environment - guidance
Electrostatic
discharge
IEC 61000-4-2
±8 kV
contact discharge
±2~15 kV air discharge
±8 kV
Horizontal Coupling
±8 kV Vertical Coupling
±8 kV
contact discharge
±2~15 kV air discharge
±8 kV
Horizontal Coupling
±8 kV Vertical Coupling
Floors should be
wood, concrete or
ceramic tile. If floors
are covered with
synthetic material, the
relative humidity
should be at least
30%.
Electrical fast
transient/burst
IEC 61000-4-4
±2 kV for power
supply Lines
±1 kV for input/output
Lines
±2 kV for power supply
Lines
Mains power quality
should be that of a
typical commercial or
hospital environment.