Instruction Manual

ManualsBrandsANOLiS ManualsLed LightingANOLIS Ambiane AP LED Lighting

INSTALLATION INSTRUCTIONS

www.anolis.eu www.anolislighting.com

AMBIANE

VERSION 1 / 24_05_2021

The unit must be installed by a qualiﬁed electrician in accordance with all national and local electrical

and construction codes and regulations.

STEP 1.A

CEILING OPENING

Prepare mounting hole with diameter between 212-214 mm.

STEP 2

PRIMARY POWER CONNECTION

Install terminal blocks on cable and connect it to the Primary power connection of Ambiane AP‘s control unit.

Use of the Adapter ring is recommended in case of a bigger ce-

iling opening. See step 6.B before connecting power and data

STEP 1.B

CEILING OPENING

Summary of content (4 pages)

PAGE 1
AMBIANE AP TM INSTALLATION INSTRUCTIONS The unit must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations. STEP 1.A CEILING OPENING STEP 1.B CEILING OPENING Use of the Adapter ring is recommended in case of a bigger ceiling opening. See step 6.B before connecting power and data Prepare mounting hole with diameter between 212-214 mm.
PAGE 2
AMBIANE AP TM INSTALLATION INSTRUCTIONS STEP 3 DATA CONNECTION (DMX OR DALI) STEP 4 SECONDARY POWER CONNECTION 48V 1 Install terminal blocks on DMX or DALI cables and connect them to the control unit. DMX CONNECT ION Install terminal blocks on cable and connect it to the control unit. 0V D- D+ Data Ground Data - Data + STEP 6.A LUMINAIRE INSTALLATION STEP 5 DIP SWITCH 1 1 Make sure power and data cables are connected before this step.
PAGE 3
AMBIANE AP TM INSTALLATION INSTRUCTIONS STEP 6.B LUMINAIRE INSTALLATION WITH ADAPTER RING 1 2 Slide Adapter ring under the control unit and above both spring. Lift up both springs and slide Adapter ring under them. 3 4 Lift up springs on both sides, insert luminaire into ceiling opening and release springs to hold lumaire in place. Install Adapter ring to position as above. ROBE lighting s. r. o. | Palackeho 416 | 757 01 Valasske Mezirici | Czech Republic | Tel.
PAGE 4
AMBIANE AP TM INSTALLATION INSTRUCTIONS STEP 7 INSTALLTION OF ACCESSORIES - ANTI-GLARE RING 1 Insert the Anti-Glare ring into the Ambiane AP until three locks snap into slots.. Click on Anti-Glare ring. ROBE lighting s. r. o. | Palackeho 416 | 757 01 Valasske Mezirici | Czech Republic | Tel.: +420 571 751 500 | E-mail: info@anolis.eu www.anolis.eu www.anolislighting.