Installation Guide

INSTALLATION INSTRUCTIONS

www.anolis.eu www.anolislighting.com

AMBIANE

XP56 PENDANT REMOTE

VERSION 1 / 10_05_2021

The unit must be installed by a qualiﬁed electrician in accordance with all national and local electrical

and construction codes and regulations. ws

STEP 1

CEILING ADAPTER INSTALLATION

Screw the spherical cap with the hanging wire to the ceiling plate.

Recommendation- use thread glue LOXEAL 5503 to prevent self

loosening of the adaptor.

Fasten the adapter to the lower ceiling.

Fasten the control unit on the ceiling by means of two holes in the

control units housing

Drill the hole Ø8mm in the lower ceiling for the LED unit supply

cable. If you wish to have the LED unit supply cable parallel with

the hanging wire, the distance between the hanging wire and the

LED unit supply cable should be 60mm

STEP 2

CONTROL UNIT INSTALLATION

PAGE 1
AMBIANE XP56 PENDANT REMOTE TM INSTALLATION INSTRUCTIONS The unit must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations. ws STEP 1 CEILING ADAPTER INSTALLATION 1 2 Screw the spherical cap with the hanging wire to the ceiling plate. Recommendation- use thread glue LOXEAL 5503 to prevent self loosening of the adaptor. Fasten the adapter to the lower ceiling.
PAGE 2
AMBIANE XP56 PENDANT REMOTE TM INSTALLATION INSTRUCTIONS STEP 3 LED UNIT CABLE CONNECTION 1 Shorten the cable to required length. 2 L ED U n i t Co n n ec t i o n TERMINAL BLOCK + A B - Colour of Wire Red White Blue Black Strip these lengths for cable connections. 3 Pull the LED unit‘s cable through prepared hole in the ceiling and secure it above ceiling. Install a terminal block on the cable and connect it to the control unit.
PAGE 3
AMBIANE XP56 PENDANT REMOTE TM INSTALLATION INSTRUCTIONS STEP 5 SECONDARY POWER CONNECTION 48V (PSU SCOPE OF OTHERS) STEP 6 IN/OUT DATA CHAIN CONNECTION 1 Install terminal blocks on DMX or DALI cables and connect them to the control unit. D M X CON N ECTI ON 2 0V D- D- Data Ground Data - Data + Set the DIP switches to positions according to your operation mode. The fixture can be controlled by DMX or DALI. Set 11=OFF for control by DMX or DALI.