Instructions

ManualsBrandsANOLiS ManualsPendant LightANOLiS AMBIANE XP56 Pendant Remote Light

INSTALLATION INSTRUCTIONS

www.anolis.eu www.anolislighting.com

AMBIANE

XP56 RECESSED

VERSION 1 / 10_05_2021

The unit must be installed by a qualiﬁed electrician in accordance with all national and local electrical

and construction codes and regulations.

STEP 1

LOWER CEILING OPENINGS

Louver is used for eliptical output. Ceiling

opening diameter must be 190mm for

application with the Louver.

Trim is used to cover opening in the lower

ceiling. Ceiling opening diameter must

be 215mm for application with the Trim.

Prepare holes in the surface (lower

ceiling) according to spacing of

mounting holes on base plate.

Assemble installation tool and secure it

by six screws.

STEP 2.A

MOUNTING - WITH FALSE CEILING ADAPTOR

Mount installation tool on the surface

and ﬁx by three screws.

Without using a Trim or a Louver, prepare

opening of 186mm diameter in lower ce-

iling.

1B 1C

With Trim With Louver

Standard

Mounting surface (structure) must safely hold at least 5 times weight of Ambianes + Adaptors placed on it.

1 2 3

Summary of content (5 pages)

PAGE 1
AMBIANE XP56 RECESSED TM INSTALLATION INSTRUCTIONS The unit must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations. STEP 1 LOWER CEILING OPENINGS 1A Standard 1B With Trim Without using a Trim or a Louver, prepare opening of 186mm diameter in lower ceiling. 1C With Louver Louver is used for eliptical output. Ceiling opening diameter must be 190mm for application with the Louver.
PAGE 2
AMBIANE XP56 RECESSED TM INSTALLATION INSTRUCTIONS 4 5 Pomocí tří šroubů připevníme nosník k povrchu Slide the Ambiane XP56 into the False Ceiling Mounting Adaptor. Fasten yoke of Ambiane XP56 to the adaptor with screw, nut and washers provided with adaptor. The Ambiane XP56 has to be secured to the ceiling (or other structure) via a safety wire pulled through the mounting lug. STEP 2.
PAGE 3
AMBIANE XP56 RECESSED TM INSTALLATION INSTRUCTIONS STEP 3 VERTICAL POSITION ADJUSTMENT 1 2 Adjust the fixture into desired position and tighten all loosened screws. To move the Yoke/luminaire up or down loosen both screws on each side of the Yoke. To tilt the Yoke/luminaire in range +/-90° loosen only the lower screw on each side of the Yoke.
PAGE 4
AMBIANE XP56 RECESSED TM INSTALLATION INSTRUCTIONS STEP 6 DATA CABLES CONNECTION STEP 5 SECONDARY POWER CABLE CONNECTION 48V (SCOPE OF OTHERS) 1 Install terminal blocks on DMX or DALI cables and connect them to the Control Unit. 2 Install terminal block on Secondary power cable and connect it to the Control Unit. D M X CON N ECTI ON 0V D- D+ Data Ground Data - Data + Set the DIP switches to positions according to your operation mode.
PAGE 5
AMBIANE XP56 RECESSED TM INSTALLATION INSTRUCTIONS STEP 7.B INSTALLATION OF LOVER (LOUVER 5°,10°) 1 2 Unscrew two M4x12 screws on each side of the Ambiane XP56. Slide the louver onto the housing of the Ambiane XP56. 3 4 There are three sets of mounting holes on the Louvre. (Size of the luminare depends on type of used optic) When the Louver is mounted on luminaire, one of those sets will match mounting holes on housing of the luminaire.