Instruction Manual

ManualsBrandsANOLiS ManualsLed LightingAnolis Divine 72 LED Lighting

INSTALLATION INSTRUCTIONS

DIVINE 72

VERSION 1.0 / 05_2021

The unit must be installed by a qualied electrician in accordance with all national and local electrical

and construction codes and regulations. This device falls under class one and must be grounded!

Inlets for power and data from bottom side of the luminaire.

STEP 1

CABLE GLAND

Inlets for power and data from side of the luminaire. Uncover junction box located on the bottom side of luminaire.

STEP 2

UNCOVER JUNCTION BOX

For bottom connection

For side connection

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS DIVINE 72 The unit must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations. This device falls under class one and must be grounded! STEP 1 CABLE GLAND 1A For bottom connection Inlets for power and data from bottom side of the luminaire. 1B For side connection Inlets for power and data from side of the luminaire.
PAGE 2
INSTALLATION INSTRUCTIONS DIVINE 72 STEP 3 CONNECTION 1 Strip these lenghts for cable connections 2 Connection – colour coding To connect the Divine 72 to mains and a DMX controller, use a 5-cored cable Flamar Li9YC11Y. The 3 colors serve for the power supply and 2 shielded cores are intended for DMX connection.
PAGE 3
INSTALLATION INSTRUCTIONS DIVINE 72 STEP 5 CLOSE JUNCTION BOX STEP 6 CABLE GLAND INSTALLATION Use wrench size 24 for cable gland M20x1.5 Use wrench size 16 for cable gland M12x1.5 Install Cable glands individually! We recommend to apply an adequate layer of the paste LOCTITE 5331 on the plastic holder of the cable gland before inserting in into the body of the gland and an adequate layer of the paste LOCTITE 577 on the thread ofthe gland body.
PAGE 4
INSTALLATION INSTRUCTIONS DIVINE 72 ACCESSORIES Optical Demo Set STEP 8 INSTALLATION OF ACCESSORIES 1 Unscrew two screws and split accessory to two parts. Place each part onto the luminaire´s head and screw them together. STEP 9 HEAD POSITION ADJUSTMENT 2 Secure accessory by 4 screws with spring washer at the back side of luminaire´s head. Release locking screw on each sides. Angle fixture to desired position and tighten locking screw on each sides. ROBE lighting s. r. o.