Installation Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- 5.1 Storage Settings
- 5.2 Basic Event Configuration
- 5.3 Smart Event Configuration
- 5.4 PTZ Configuration
- 5.4.1 Configuring Basic PTZ Parameters
- 5.4.2 Configuring PTZ Limits
- 5.4.3 Configuring Initial Position
- 5.4.4 Configuring Park Action
- 5.4.5 Configuring Privacy Mask
- 5.4.6 Configuring Scheduled Tasks
- 5.4.7 Clearing PTZ Configurations
- 5.4.8 Configuring Smart Tracking
- 5.4.9 Prioritize PTZ
- 5.4.10 Position Settings
- 5.4.11 Rapid Focus
- Chapter 6 Camera Configuration
- Appendix
You can select this mode when there are sodium lamps installed near the speed dome.
ATW
In ATW mode, white balance is continuously being adjusted in real-time according to the color
temperature of the scene illumination.
Image Enhancement
Note:
The functions vary depending on different camera models.
3D Digital Noise Reduction
You can set Digital Noise Reduction function to Normal and adjust the Noise Reduction Level as
shown in Figure 6-34. The level ranges from 0 to 100.
Figure 6-34 3D Digital Noise Reduction
If you are a professional technician, you can set it to Expert Mode then adjust Space DNR Level
and Time DNR Level. The level ranges from 0 to 100.
Figure 6-35 Expert Mode
Defog Mode
You can set the Defog Mode to Auto, ON or OFF as you need.
Figure 6-36 Defog Mode
EIS (Electronic Image Stabilization)
You can set the EIS to ON or OFF as you need.
Figure 6-37 Electronic Image Stabilization
OIS (Optical Image Stabilization)
You can set the OIS to NORMAL, EXPERT, or OFF as you need.
Note:
The function is only available for certain camera models.