User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- 5.1 Storage Settings
- 5.2 Basic Event Configuration
- 5.3 Smart Event Configuration
- 5.3.1 Configuring Intrusion
- 5.3.2 Configuring Line Crossing Detection
- 5.3.3 Configuring Region Entrance Detection
- 5.3.4 Configuring Region Exiting Detection
- 5.3.5 Configuring Unattended Baggage Detection
- 5.3.6 Configuring Object Removal Detection
- 5.3.7 Configuring Face Detection
- 5.3.8 Configuring Audio Exception Detection
- 5.4 PTZ Configuration
- Chapter 6 Speed Dome Configuration
- Appendix
User Manual of Network Speed Dome
38
Figure 5-13 Linkage Method
Check the checkbox to select the linkage method. Notify Surveillance Center, Send Email,
Upload to FTP/Memory/NAS, and Trigger Recording are selectable.
Linkage method varies depending on different speed dome models.
Notify Surveillance Center
Send an exception or alarm signal to remote management software when an event occurs.
Send Email
Send an email with alarm information to a user or users when an event occurs.
To send the Email when an event occurs, you need to refer to Section Configuring Email
Settings to set the Email parameters.
Upload to FTP/Memory/NAS
Capture the image when an alarm is triggered and upload the picture to a FTP server.
You need a FTP server and set FTP parameters first. Refer to Section Configuring FTP
Settings for setting FTP parameters.
Trigger Recording
Record a video when an event occurs.
You have to set the recording schedule to realize this function. Refer to Section 5.1.1
Configuring Recording Schedule for settings the recording schedule.
5.2.2 Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm actions when the lens is covered.
Steps:
1. Enter the Video Tampering settings interface :
Configuration > Event > Basic Event > Video Tampering