User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- 5.1 Storage Settings
- 5.2 Basic Event Configuration
- 5.3 Smart Event Configuration
- 5.3.1 Configuring Intrusion
- 5.3.2 Configuring Line Crossing Detection
- 5.3.3 Configuring Region Entrance Detection
- 5.3.4 Configuring Region Exiting Detection
- 5.3.5 Configuring Unattended Baggage Detection
- 5.3.6 Configuring Object Removal Detection
- 5.3.7 Configuring Face Detection
- 5.3.8 Configuring Audio Exception Detection
- 5.4 PTZ Configuration
- Chapter 6 Speed Dome Configuration
- Appendix
User Manual of Network Speed Dome
47
The Sensitivity of the detection is supported by certain models. Refer to actual display for
details.
9. Repeat the above steps to configure other regions. Up to 4 regions can be set. You can click
Clear to clear all pre-defined regions.
10. Click Arming Schedule to enter the arming schedule setting interface. The time schedule
configuration is the same as the settings of the arming schedule for motion detection. Refer
to Section 5.2.1 Configuring Motion Detection.
11. Click Linkage Method to select the linkage method taken for unattended baggage detection.
Refer to Section 5.2.1 Configuring Motion Detection.
12. Click Save to save the settings.
5.3.6 Configuring Object Removal Detection
Purpose:
Object removal detection function detects the objects removed from the pre-defined region,
such as the exhibits on display, and a series of actions can be taken when the alarm is triggered.
Steps:
1. Enter the Object Removal Detection settings interface:
Configuration > Event > Smart Event > Object Removal Detection