Installation Manual

Causes the camera to blur. The solution is to remove the camera cover clean the
camera lens and glass, then been power for the camera for more than 1~2 hour, turn
the humid into a dry air. Then reinstall the cover. Then It will become normal. It is
ease to remove the cover.
If you already have installed the camera, you only need loosen camera screw, make
the camera breathable, been power for the camera for more than 1~2-hour, Air-dried
water vapor. Turn the humid into a dry air.
5. Wireless Signal Issue
How to Get Better Wireless Connection between Camera and NVR When you hook
up cameras?
If there are obstacles between NVR and camera, adjust the height of camera or don’
t install camera and NVR in different floors. Floors normally block more wireless
signal than walls. The cameras can't be installed too far from the NVR in a house built
with concrete blocks. NVR and antennas should not be close to a wireless phone,
WIFI AP, electric motor, engine or electric transformer. These create a lot of wireless
interference and cause signal levels from the camera to vary a lot.
1) Please place the WIFI NVR and Cameras in opening area, and keep away from wall,
metals and glass.
2.) Please keep the camera's antenna in parallel with the NVR's antenna in order to
get better wifi signal.
3.) If the signal is too weak to work, please replace the camera's antenna to10ft WIFI
extension cable.