Specifications

Menu Name Function Description GPIB Mnemonic
NETWORK
EXTRACTION
THE ‘OUTER’ AND
‘INNER’ CALIBRATION
FILES MUST EXIST IN
THE CURRENT
DIRECTORY
GENERATE S2P FILE Changes the soft-key display to the next NETWORK
EXTRACTION menu.
None
HELP ON/OFF Displays an informational help screen. HELP1; HELP0;
HELPX?
RETURN Returns to the previous soft-key menu. None
NETWORK
EXTRACTION
RECALL FROM DISK
THE CALIBRATION FILE
FOR THE ‘OUTER’
(’INNER’) CAL FROM
HARD DISK Changes the soft-key display to the SELECT FILE TO
READ menu.
None
FLOPPY DISK None
RETURN Returns to the first NETWORK EXTRACTION menu. None
NOISE FIGURE
CALIBRATION
APPLY CAL
NOISE FIGURE ONLY
((NO) CAL EXISTS)
Applies the existing noise figure calibration. NFC1; NFCX?;
NFCDONE?
NOISE FIGURE WITH
12 TERM
(NO CAL EXISTS)
Applies the existing 12-term noise figure calibration.
Not allowed unless Noises Figure calibration was
done with 12-term calibration.
This menu selection is not allowed unless a Noise
Figure calibration was done with a 12-term
calibration.
NFC2;
NFC12TDONE?;
NFCX?
NONE Applies no Noise Figure calibration. NFC0; NFCX?
PERFORM CAL None
NOISE FIGURE ONLY Starts calibration and changes soft-key display to the
NOISE FIGURE CALIBRATION 2 menu. Not allowed
without a valid 12-term calibration.
BEGNF
NOISE FIGURE WITH
12-TERM
Starts calibration and changes soft-key display to the
NOISE FIGURE CALIBRATION 2 menu. Not allowed
without a valid 12-term calibration.
This menu selection is not allowed without a valid
12-term calibration in the 50 MHz to 3 GHz range.
BEGNFRF
HELP ON/OFF Displays an informational help screen. HELP1; HELP0;
HELPX?
NOISE FIGURE
CALIBRATION2
CONNECT A THROUGH
LINE BETWEEN A
NOISE SOURCE AND
PORT 2
None
ABORT CAL Changes the soft-key display to the NOISE FIGURE
CALIBRATION menu.
ABORTCAL
MEASURE DEVICE(S) Restarts measurement without going through all
steps again.
None
CAL FRONT PANEL
KEY MENUS OPERATION
4-164 MS462XX OM