Specifications

Menu Name Function Description GPIB Mnemonic
SOURCE 1 FLAT
TEST PORT
POWER
CALIBRATION
XXXX POINTS
MEASURE 1 PWR
POINT EVERY XX
POINT(S)
Displays the number of power points (0-50) to be
skipped during the power sweep. The points not
measured are interpolated to provide a flat sweep.
The VNMS uses Port 1 power for source 1 and Port 3
power for source 2.
PTS; PTS?
POWER TARGET XX.XX
dBm
Sets a flat output-power value. PTP; PTP?
BEGIN CAL Changes the soft-key display to the FLAT TEST
PORT POWER CALIBRATION menu.
SFC
RETURN Returns to the previous soft-key menu. None
PORT 1 CAL WILL
BE APPLIED TO
PORT 2
None
START
HARMONIC
CALIBRATION
ENHANCEMENT CAL
((NO) CAL EXISTS)
Changes the soft-key display to the HARMONIC
ENHANCEMENT CALIBRATION menu.
BEGEN;
HARCEDONE?
PHASE CAL
((NO) CAL EXISTS)
Changes the soft-key display to the HARMONIC
PHASE CALIBRATION menu.
BEGPH;
HARCPDONE?
ENHANCEMENT &
PHASE CAL
Changes the soft-key display to the HARMONIC
ENHANCEMENT CAL menu, then on to HARMONIC
PHASE CAL menu.
BEGHAR;
HARCEPDONE?
EXIT Changes the soft-key display to the FREQUENCY
menu.
None
TEST SIGNALS
SOURCE 1 POWER
XX.XX dBm
(20TO-15dB)
Enter the power level, in dBm, of the internal source. PWR; PWR?
PORT 1 ATTN
0*10 dB(0-70dB)
Attenuates from 0 to 70 dB (10 dB steps) the
microwave power being output at Port 1.
SA1; SA1?
PORT 1 POWER
XX.XX dBm
Displays the Port 1 power, in dBm. P1P?
CALIBRATE
FOR FLATNESS
( (NO) CAL EXISTS)
Changes the soft-key display to the SOURCE 1 FLAT
TEST PORT POWER CALIBRATION menu.
None
FLATNESS ON/OFF
CORRECTION
Toggles flatness correction on or off. FP1; FP0; FPX?
SOURCE 2 POWER
X.XX dBm
Enter the power level, in dBm, of the 2nd frequency
source.
PW2; PW2?
RESUME CAL Changes the soft-key display to the CONFIRM
CALIBRATION PARAMETERS menu.
None
THRU
ASSIGNMENT
(FULL 2 PORT CAL)
THRU (1-2)
AUTOCAL
/THRU
LINE LENGTH
0.000 mm
Select thru type for port 1-2. Enter the line length
offset if true thru is selected.
ACF2TC; ACF2TT;
ACF2TX?;
ACTHRU12T0;
ACTHRU12T1;
ACTHRU12TX?;
ACTOLP12;
ACTOLP12?
RETURN Changes the soft-key display to the AUTOCAL
SETUP (FULL 2-PORT CAL) menu.
None
CAL FRONT PANEL
KEY MENUS OPERATION
4-174 MS462XX OM