Specifications

Chapter 5
Error and Status
Messages
5-1 INTRODUCTION This chapter lists, describes, and provides corrective action for the
error messages that appear on the display. Any error messages that
appear on the display but do not appear in this chapter will require
action by a qualified service representative.
5-2 ERROR MESSAGES Error messages are provided in Tables 5-1 through 5-4.
MS462XX OM 5-3
Code Message Description Corrective Action
Troubleshooting Error Codes
ALC SHAPER DAC CAL FAIL ALC CAL fail Contact factory
DSP NMI ERROR Contact factory
DSP ST ERROR DSP self-test fail Contact factory
FLASH WRITE ERROR FLASH memory write fail Contact factory
FLASH ERASE ERROR FLASH memory erase fail Contact factory
MEMORY TEST ERROR
NCR ACC1 ERROR Hard drive controller test fail Contact factory
NCR ACC2 ERROR Hard drive controller test fail Contact factory
NCR SFIFO ERROR Hard drive controller test fail Contact factory
NCR DFIFO ERROR Hard drive controller test fail Contact factory
NCR LPBK ERROR Hard drive controller test fail Contact factory
NCR SCRIPT ERROR Hard drive controller test fail Contact factory
NCR IRQ ERROR Hard drive controller test fail Contact factory
LANC SELF TEST_ERROR LANC controller test fail Contact factory
LANC IRQ ERROR LANC controller test fail Contact factory
LANC REG STATE ERROR LANC controller test fail Contact factory
LANC DUMP TEST ERROR LANC controller test fail Contact factory
LANC DIAG ERROR LANC controller test fail Contact factory
LANC SCB ERROR LANC controller test fail Contact factory
LANC CANT IDLE ERROR LANC controller test fail Contact factory
LANC IRQ PENDING ERROR LANC controller test fail Contact factory
LANC IDLE ERROR LANC controller test fail Contact factory
LANC TIMEOUT ERROR LANC controller test fail Contact factory
LANC CONFIGURE ERROR LANC controller test fail Contact factory
LANC SETUP ERROR LANC controller test fail Contact factory
Table 5-1. General Error Messages (1 of 7)