Specifications

change reflects the changes in measurement data at
the marker’s new frequency, using data stored from
the previous sweep.
Display of
Markers
Once you have selected a marker to display, it will
appear on the screen. It does not matter what reso
-
lution you have selected. When you set a marker to
another calibrated frequency and then lower the
resolution, that frequency and the marker will con
-
tinue to display. It will display even if its frequency
is not consistent with the data points in the
lower-resolution sweep.
6-7 HARD COPY AND DISK
OUTPUT
In addition to the LCD display, the Model MS462XX is capable of
outputting measured data as a
q
Tabular Printout
q
Screen-Image Printout
q
Pen Plot
q
Disk Image of the Tabular Data Values
The selection and initiation of this output is controlled by the Hard
Copy keys.
Tabular
Printout
The tabular formats are used as follows:
q
Tabular Printout Format: Used when
printing three or four channels
q
Alternate Data Format: Used when printing
one or two channels
In tabular printouts, the MS462XX shifts the data
columns to the left when an S-Parameter is omitted.
Leading zeroes are always suppressed. The heading
(Model, Device ID, Date, Operator, Page) appears on
each page.
Screen-Image
Printout
In a Screen-Image Printout, the exact data
displayed on the screen is dumped to the printer.
The dump is in the graphics mode, on a
pixel-by-pixel basis.
HARD COPY DATA
AND DISK OUTPUT DISPLAYS
6-18 MS462XX OM