Specifications

Step 9. Remove the flush short by holding its body and un
-
screwing its connector.
Step 10.
Install the gauge onto the end of the sliding
termination.
Step 11.
If the COARSE SET adjustment—which has been
set at the factory—has not moved, the inner dial on
the gauge will read “0.” If it doesn’t, perform the
Coarse Set Adjustment in step 15.
Step 12.
Place the sliding termination, with the gauge
attached, on the bench top.
MEASUREMENT CALIBRATION MEASUREMENT
SLIDING- TERMINATION CALIBRATION
7-16 MS462XX OM