Specifications

Step 13. Loosen the FINE LOCK ring and turn the FINE

ADJ ring to position the gauge pointer 2-3 small di

visions on the “–” side of zero.

Step 14.

Turn the FINE LOCK ring clockwise to both tighten

the adjustment and place the pointer exactly to “0.”

The Sliding Termination is now ready to use.

NOTES

· Ensure that the inner dial reads “0”

· The following step is not normally neces-

sary. It needs to be done only if the ad-

justment has changed since it was set at

the factory

Step 15.

With the 01-211 Flush Short installed, loosen the

COARSE LOCK and gently push the COARSE SET

adjustment rod in as far as it will go. This coarsely

sets the center conductor to be flush against the at

tached short. Return to Step 2.

Step 16.

The procedure for adjusting the male-connector

sliding termination is essentially the same as that

described above. The only difference is that you

must install the female adapter on the end of the

gauge shaft, over the center conductor. To install

this adapter, proceed as follows:

Zero-set the gauge as described in Step 2

Push the outer locking ring back toward the

gauge and turn it clockwise onto the exposed

threads

Loosen the lock ring one turn in a

counterclockwise direction

MEASUREMENT MEASUREMENT CALIBRATION

CALIBRATION SLIDING -TERMINATION

MS462XX OM 7-17