Specifications

9-9 PIN DEPTH
SPECIFICATIONS
The depth of the center pin on connectors is a critical specification,
which if not met, can cause damage to mating connectors. Table 9-1
provides pin-depth specifications for associated AutoCal connectors
and Table 9-2 provides pin depth examples.
PIN DEPTH SPECIFICATIONS AUTOCAL
9-16 MS462XX OM
Device Connector Pin Depth (inches)
3658XXX K-Female +0.0000 to -0.005
3658XXX K-Male +0.0000 to -0.005
3658XXX N-Female *[0.207](+0.000, -0.005)
3658XXX K-Female *[0.207](+0.000, -0.005)
32K50
32KF50
K-Male (cable side) **Negative Indication
K-Female +0.0000 to -0.0005
K-Male (DUT side) +0.0000 to -0.0005
32L50
32LF50
K-Male (cable side) **Negative Indication
3.5mm-Female (DUT side) +0.006 to -0.008
3.5mm-Male (DUT side) +0.006 to -0.008
32S50
32SF50
K-Male (cable side) **Negative Indication
SMA-Female (DUT side) +0.0005 to -0.0015
SMA-Male (DUT side) +0.0005 to -0.0015
*Gauging Type N Connectors: The actual value of a Type N master gauge block will always vary to some degree from the
desired nominal value. The recorded measured value of the master gauge must be observed when calibrating the Pin
Depth Gauge to the desired nominal value. Although the AutoCal Module Pin Depths are not critical, this information may
be helpful in the measurement of Type N mating components. Examples are shown in Table 9-2, on the following page.
Table 9-1. AutoCal Module Connector Pin Depth Specifications