Specifications

13.
SCSI-2: Provides for connecting an external SCSI-2 hard disk drive (Option 4). Figure B-7 provides a
pinout diagram.
14.
LPT Line Printer: 25-pin connector that provides a parallel interface to the companion printer.
Figure B-2 describes the signal lines and shows the connector pinout.
15.
Ext Trigger: Allows an external signal to sync the MS462XX measurements; ±1V trigger.
16.
Ext Analog Output: Providesa0to±10V signal for use in driving an external plotter or antenna
(CW draw).
17.
VGA: 15-pin connector provides VGA output of MS462XX video display. Figure B-4 provides a pinout
diagram.
18.
Ethernet: Provides for connecting the MS462XX to a network using an Ethernet-type connector.
Figure B-5 provides a pinout diagram.
19.
Serial Port: Provides control for AutoCal module. Figure B-6 provides a pinout diagram.
20.
Dedicated GPIB: IEEE 488 standard 24-pin connector that allows the MS462XX to remotely
control a second, third, and up-to-a-fourth frequency source, an external plotter, analyzer, or other
peripheral. Figure B-1 provides a pinout diagram.
21.
IEEE 488.2 GPIB: IEEE 488 standard 24-pin connector that provides for remotely controlling the
MS462XXX from an external computer/controller via the IEEE-488 bus (GPIB). Figure B-1 provides
a pinout diagram.
MS462XX REAR REAR PANEL
PANEL CONNECTORS
B-6 MS462XX OM