Specifications

Index 12 Stimulus Keys
Freq: Displays the first in a series of menus that provide fre
-
quency-sweep control and let you trigger I.F. calibration measure
-
ments. See page 4-62.
Sweep: Displays the first in a series of soft-key menus that provide
frequency-sweep control. See page 4-65.
Power: Displays the first in a series of menus that provide RF power
control. See page 4-70.
Config: Displays the first in a series of soft-key menus that provide
control over measurement configuration. See page 4-77.
Index 13 Probe Power Connector: Provides bias voltages of +15 or -12 Vdc
(Figure 4-2) for an external high-impedance probe.
Index 14 Channel Keys
Ch 1: Makes Channel 1 the active channel. The active channel is
the one acted on by the keys in the Display section. Only one channel
can be active at any one time.
Ch 2: Makes Channel 2 the active channel.
Ch 3: Makes Channel 3 the active channel.
Ch 4: Makes Channel 4 the active channel.
Index 15 Enhancement Keys
Seq: Displays a series of sequencing menus that allow you to create,
modify, and store up to seven sequences that can be executed automati
-
cally. See page 4-121.
Cal: Calls up the first in a sequence of menus that guide you
through a measurement calibration. See page 4-129.
Avg: Displays a menu that lets you control the Average, Smoothing,
and IF Bandwidth functions. See page 4-182.
Utility: Displays the first in a series of menus that let your perform
network, diskette, auto cal characterization and assurance, trouble
shooting and other utility functions. See page 4-88.
FRONT PANEL FRONT PANEL
KEY DESCRIPTIONS OPERATION
4-4 MS462XX OM
GND
-12
+15
Figure 4-2. Probe Power Connector Pinout
Pin-voltage assignment
when looking into the
connector.