User's Manual

14.2 Dismantling the bolt
X Twist the bolt head [a] through approx. 90°.
[b][a]
Fig.15 Dismantling the bolt
X Pull the bolt head [a] over the interlock on the middle section
of the bolt [b].
Fig.16 Pulling off the bolt head
X Remove the firing pin [x] and the interlocking spring [y].
[y]
[x]
Fig.17 Removing the firing pin and coil spring
X To reassemble, carry out these steps in reverse.
The bolt head [a] should engage with the middle
section with the bolt handle [b], as shown in Fig. 14.
NOTE!
17