03/04 Bedienungsanleitung Instruction Leaflet KK-Matchgewehr Biathlon Small Bore Biathlon Rifle Mod. 1827 ANSCHUTZ Fortner ~ . Bitte sorgfCiltig lesen, bevor Sie dieses Gewehr zusammenbauen oder benutzen. Please read carefully before you assemble or operate this rifle.
Index Definitions. .5.03 Preface ................... .5.21 Safety instructions.............. .5.21 General handling of rifles. .5.22 Ear and eye protection. .5.24 Laws ..... .5.24 Liability ............. .5.24 Technical data ................................ .5.25 Assembly, fitting the AN5CHUTZ barreled action .5.25 Cocking, loading and safety operation. ..5.25 Unloading. .. 5.26 Magazine. .5.26 Bolt .5.26 Trigger .5.27 Trigger adjustments. .5.27 Dry firing device.. .5.32 5ight set 5.
/ Begriffsbestimmungen Definitions 4 3 5 6 9 1 2 3 4 5 6 7 8 9 10 11 12 13 Schaftbacke Biathlondiopter PatronenauswurF Biathlon Magazin Spezial BiathlonlauF Korntunnel mit Schneeklappe Mundung Biathlonkappe Biathlonschaft Abzug Geradezugverschluss Magazinschacht Magazinhalter 1 2 3 4 5 6 7 8 9 10 11 12 13 Cheek piece Biathlon rear sight Ejection Biathlon magazine Special Biathlon barrel Front sight with snow cover Muzzle Biathlon butt plate Biathlon stock Trigger Straight pull action Magazine well
Preface Dear Friends of ANSCHUTZ, You have made a good choice, now that you have decided to buy an ANSCHUTZ product. The many great results obtained with ANSCHUTZ rifles by target shooters, participants in the Olympic Games as well as in World and European championships throughout the world made your choice easy, as your rifle has benefited from our great experience of making fine sporting and target rifles since 1856.
~ Warning: This rifle can be dangerous correctly observed. or if this instruction The privilege if it is not used leaflet is not of ownership and safe use of your rifle carries a personal responsibility that no one should take lightly. Rifle accidents following rules would not occur if the of shooting safety were observed. General pistols Although handling of rifles and it can be assumed that shooters are familiar with the following would like to emphasize for reasons of safety.
shoot at a skyline target or into the air. Do not shoot at anything from which a bullet might ricochet. Never fire your rifle with the muzzle in the water material to avoid or against an accident any other or damage and especially when you are not present your rifle is well secured, out of any reach of children and other unauthorized and in no way accessible safe storage persons to them. For the of your rifle even in a locked of your rifle.
11. You must be in good physical and mental influence health and of any substance condition not under (drugs, alcohol) which might impair vision, dexterity or judgement. Do not use your rifle when you are tired. Tiredness Liability the may result in a loss of 1. ANSCHUTZ does not assume any responsibility or payment of damage claims for damages of any kind resulting from the disregard of these instructions, non-qualified treatment control. or repair, the use of non-original ANSCHUTZ 12.
at the bottom KK-Biathlon Small bore target Mod. rifle 1827 ANSCHUTZ . however. Screw in the bedding 1827 ANSCHUTZ Fortner .22 I.r. 55 cm / 21.6" 55 cm / 21.6" 104 cm / 40.9" 1827 ANSCHUTZ Caliber: Barrel length: Rifling: Totallength: Totallength barreled action: Weight approx.: Version: Fortner Sprint nitride .22 I.r. 55 cm / 21.6" 55 cm / 21.6" 104 cm / 40.9" 73 cm / 28.7" 4,0 kg / 8.8 Ibs Repeater 73 cm / 28,7" 3,7 kg / 8.
There is a safety lever at the left side, which The bottom of the magazine deactivates forward to accept further cartridges. cartriges one after the other. the safety mechanism in the front position. can be pushed Fill in The rifle is . . safe, when the (safe) is visible but the "S" (fire) is covered. "F" ready for shooting when the (fire) is "F" (safe) is covered. visible but the "S" Please note: The safety lever must latch properly and audibly, never between the two positions.
Bolt To remove .. . .. . the Fortner bolt Pull back the bolt (1 ). Pull back the thumb spring (22) a little and turn it to the right until the groove is in line with the breech wedge (24). Remove the breech wedge by pulling it backwards. Screw off the breech (23). Pull back the bolt handle (15) under tension. By holding the bolt handle and hold it the locking balls (12) are free of load. Remove bolt by pulling it backwards.
. grease them a little they will not fallout). To reassemble the bolt parts attach the screwed conduit sleeve with its teeth opposite to the direction of fire to the rear bolt partthus connecting itto the chamber. The screwed conduit sleeve has two opposing threads each of which is connected to the referring bolt part. Tighten screwed conduit sleeve manually until it is no longer possible to turn the chamber. The tip of the firing pin must protrude over . . the action face of the chamber.
changed there will always be a corresponding change of the other as well. To move trigger .lowest position . eam No. 11: of the trigger lowest trigger weight highest position of the trigger cam: cam: highest trigger weight If the trigger weight is to be more than 200 g, I OGO oe 0 e f) 00 the trigger 4D to (turn it by 1800 and fix it then). To do this you need a 2 mm hex key and perhaps tweezers. Trigger G Warning: . .
. if you turn it to the left: first stage weight is decreased Make sure your rifle is not loaded. Cock your rifle and release the trigger. Check if (-) the trigger Trigger weight and first stage depend on each other with regard to the mechanic mechanism. If one of them is changed there will always be a corresponding change of the other as well. ~ releases as desired. weight The sear engagement There is a small Do not reduce . .
. if you turn it to the left: overtravel ~ is extended Attention: The trigger stop set screw No.8 can be turned over the second stage or first stage function. Malfunction release)! (the trigger does not 6. Adjustment of the trigger blade 0 e f) 00 I OGO oe 4D Adjustment offirst stage with set screw No.4: . . .. Loosen hex screw No.7 Trigger blade No.6 longitudinal guide can be moved in the and can be tilted laterally. if you turn it to the right: 7.
there might increased be a malfunction risk and (inadvertent an shot release). 8. Change two-stage . . . .. . of single stage trigger is attached correctly. stop set screw No.8 is 'The trigger screwed in too much. Turn it a few turns to the left until the cocking pin will release again. into piston or firing trigger The trigger does not catch the cocking Turn trigger stop set screw No.8 approx. piston or firing 2 112 turns to the left (adjust max. trigger stop longer).
~ Please attach Attention: If you change the trigger remove the bolt from the receiver when fitting the trigger as otherwise the trigger will be damaged. pin is adjusted ignites the cartridges. so If there is no cartridge or cartridge case in the chamber, the firing pin as well as the rim of the chamber may be damaged when dryfiring for a longer period. In order to prevent any possible cartridge use either a case) or preferably down disc 1927F-40.
~ Sight Set Assembly Attention: The rear sight is pushed onto the rail of Your ANSCHUTZ rear sight has been adjusted carefully and without play with the help of special tools. It has been checked 11 mm width and fixed with the 2 screws (tighten manually). several times and therefore does not require any additional adjustments. Therefore only Vertical tal adjustments operate the screws for vertical and horizonand horizontal adjustment The screws for vertical and horizontal adjustment have clicks.
many residues would remain in the barrel is horizontal avoid at low temperatures. or even with the stock up to any contamination of the trigger mechanism. After .. initial shooting: Dry clean (remove powder Leave the rifle locked Protect your rifle against dust, sand, humidity, heat and other harmful influences. residues). and the snow cap closed, do not take into a warm room. After . . . . competition: Vacuum clean your gun case or soft gun case once a month to remove dust and lint.
the article in question and the corresponding purchase receipt plus filled-in warranty card are presented. Warranty not be accepted if changes will or repair works All rights of this instruction permission Co. KG and otherwise not authorized, if the rifle is not used correctly or if non-ANSCHUTZ original parts were used.
««GARANT IE»» Dieser Artikel wurde zum Verkauf freigegeben, nachdem er selbst, seine Materialien und Einzelteile strenge Kantrallen durchlaufen haben, ader das Gewehr beim Beschuss seine Haltbarkeit und Funktian unter Beweis gestellt hat. Wir ubernehmen fur zwei Jahre valle Garantie auf Material- ader Bearbeitungsfehler (ausgenammen Schaft- und Federbruche), safern ein Mangel nachweisbar bereits im Zeitpunkt der Obergabe des Artikels varlag.
««GARANTIE»» ««W Cet article n'a ete mis en vente qu'apres une verification minutieuse des pieces et matieres taus les stades de 10 fabricatian au apr"s avair subi un cantr61e de fiabilite et de bon fonctionnement au bane d'epreuve. Nous 10 garantissons pendant deux ans contre tout defaut de matiere au vice de fabricatian (sauf cantre les bris de crasse au de ressarts) dans la mesure au il peutiHre prauve qu'un defaut existait deja au mament de I'achat de I'article.
Fabr.-Nr.: Seria I No.:.......................................................................... Bitte hier eintragen . Please fill in here Originalschussbild Ihres Gewehres 5 Schuss auf 50 m Original group of your rifle 5 shots at 50 m ~ DIE MEISTER MACHER J.G. ANSCHUTZ GmbH & Co. KG Jagd- und Sportwaffenfabrik Daimlerstrasse 12 D-89079 Ulm / GERMANY PostFach11 28 D-89001 Ulm / GERMANY TeleFon(++49)-(0)-731-4012-0 TeleFax(++49)-(0)-731-4012-700 anschuetz-sport.com JGAl nFo@anschuetz-sport.
