User manual

 
The grip, the cheek piece and the forend of the
aluminium shaft are made from PRO-Grip material.
These parts can be adapted to the requirements
of the marksman. The PRO-Grip material can be
treated as wood for this purpose. If the surface of
the cheek piece is too rough, this can be smoothed
down using fine glasspaper (grain size 200).


Operating and maintenance instructions can be
found in the individual manufacturer's documenta-
tion.

 
The rear sight is slid on to the 11 mm wide V-block rails and locked in
a suitable position using the 2 clamping screws (just tighten hand-tight).
 
The elevation and windage adjusting screws have click stops.
The position of the aiming point is moved from click to click.
y Elevation when shooting high = turn rotary knob in "H" direction
y Elevation when shooting low = turn rotary knob in "T" direction
y Windage when shooting to the right = turn rotary knob in "R" direction
y Windage when shooting to the left = turn rotary knob in "L" direction
 
After the sights have been zeroed, the two adjusting screws can be set
to the "0" position.
X Release the set screws in the rotary knob.
X Position the rotary knobs to "0" on the scale.
X Tighten the set screws in the rotary knob hand-tight.
$$ The$ANSCHÜTZ$rear$sight$is$aligned$with$zero$clearance$at$the$factory$and$does$not$require$
further$adjustment.$For$this$reason$only$the$elevation$and$windage$screws$may$be$operated.
$$ Do$not$turn$the$knobs$beyond$the$stops$at$the$end$of$the$adjustment$travel$$
(the$pre-tensioned$threaded$drive$can$be$damaged).
