Installation guide

6. Connect the LAN cable to Ethernet’s switch or hub, the video cable to video output to
the monitor or other video device through a 75 Ohms type coaxial cable and the
DC-Jack to the power source.
7. Vari-Focal Dome Operation Guide: Once the picture appears on the monitor, open
the cover and adjust the lens wrench to “NEAR←→FAR”, get the view zoom that you
desire, and then adjust the focus wrench of the lens to obtain the best picture. After
adjustment, tighten both wrenches.
Zoom Adjustment
Focal Adjustmen
t
NEAR
FAR
WIDE
TELE
8. Connect the necessary cables and connectors:
- Plug-in Ethernet Cable into LAN port (necessary)
- Connect the attached 12V power adapter to camera and plug-in this adapter
into power outlet (necessary)
- Connect Video BNC connector to a local TV if necessary (to check camera
viewing angle)
9. Done