User Manual

the two units for initial RF setup. Once the RF connection is established, place the main unit within the
effective transmission range from the transmitter. Shorten the distance if necessary for best reception.
- To search for RF signal from a new PC Transmitter, press [PC SEARCH] button on the main unit repeatedly
until the RF antenna icon flashes.
- Press [TRANSMIT] button on the PC Transmitter to enforce transmitting RF weather data to the main unit
- Once the RF connection is established between the main unit & PC transmitter, the RF icon “ “with full
strength & “LAST UPDATE: TODAY” will appear on the main unit. In the first few minutes of the RF
reception, the main unit is showing data on one part of the screen and this is normal. The rest of the screen
display data will gradually appear in the next 10 minutes to 1 hour.
NOTE:
- If you have waited 1 hour or more without seeing the rest of the screen, shorten the distance between the
PC transmitter & main unit, check the battery levels and repeat the setup procedure above
- If it continues to fail, try removing the USB connection and all batteries from the PC transmitter. Reinstall the
batteries and then reconnect the USB connection again. Repeat above procedure to set up the RF
connection
LOCAL WEATHER INFORMATION (For W194-X/W194-1)
MAIN UNIT’S DISPLAY
A & B) INDOOR & OUTDOOR TEMPERATURE
Press [C/F] button to select temperature unit C/ F.
Press [CHANNEL/SEARCH] to select Ch1, Ch2, Ch3 and auto-channel scrolling display modes.
The arrow icons will indicate rising, steady or falling according to the trend of the temperature measurements in
the past hour.
Hold [CHANNEL/SEARCH] to search for RF signal from remote sensor (See “SETTING UP THE REMOTE