User's Manual

User manual for Wireless Rain Gauge

(1) Features

- Digital Time (12/24hr selectable)

- Date & Day

- Rainfall per Day

- Rainfall per Week, per Month, or Accumulated Rainfall

- mm/inch selectable

(2) Functions Key

“SET” Used to set the time

“+” Step Advanced/ Fast Advanced

Or Reset the record of rainfall

Or Cancel the registration of Rain Gauge

“-“ Step backward/ Fast Backward

Or Change mode of Rainfall per week/ per month/ accumulated record

Or Change the units of Rainfall

(3) Battery Installation

- First to install the battery of Home Unit 2pcs AAA.

- Open the battery door of Rain gauge by screwdriver, insert 2pcs AA battery and

close it with screwdriver. It should be placed near the Home unit.

- It is important to install the battery for Home unit first in order to have a good

reception for the signal for registration.

(4) Registration :

(a) Automatic Registration started after installation of battery for both rain gauge and

home unit. The LCD of home unit will show zero “0” or a number for the rainfall if

registration success. Otherwise, please re-install the batteries of the Rain gauge again.

(b) You can cancel the registration by pressing and holding the button “+” for 3

seconds. The LCD will show flashing “- - - -“.

(5) Place of Rain Gauge

In order to have precise reading, you are highly recommended to put the rain gauge on

horizontal place, no rock or other thing on the ground. Besides, there should be no any

obstacle around the gauge within 3m such as building, trees, house and etc, which will

affect the reading of the rain gauge.

Noted : You need to change the position of Rain Gauge if the rainfall shows "- - - -". It

means that the reception of signal fail in last hour, which may be affected by other

signal or interference.

PAGE 1
User manual for Wireless Rain Gauge (1) Features - Digital Time (12/24hr selectable) - Date & Day - Rainfall per Day - Rainfall per Week, per Month, or Accumulated Rainfall - mm/inch selectable (2) Functions Key “SET” Used to set the time “+” Step Advanced/ Fast Advanced Or Reset the record of rainfall Or Cancel the registration of Rain Gauge “-“ Step backward/ Fast Backward Or Change mode of Rainfall per week/ per month/ accumulated record Or Change the units of Rainfall (3) Battery Installation - Fi
PAGE 2
(6) Setting for Home unit : Before any setting, check the home unit is worked properly and receipt the signal from the Rain gauge. If reception is successful, the LCD will show the data information for rainfall either “zero” or a number. If show flashing “- - - - “, it means reception failure. Then you need to re-install the battery again for Home unit (follow #8). If all OK, you need to reset the readings of Home unit by pressing button “+”.
PAGE 3
Modifications not authorized by the manufacturer may void users authority to operate this device. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.