User's Manual

(6) Setting for Home unit :
Before any setting, check the home unit is worked properly and receipt the signal from
the Rain gauge. If reception is successful, the LCD will show the data information for
rainfall either “zero” or a number. If show flashing “- - - - “, it means reception failure.
Then you need to re-install the battery again for Home unit (follow #8).
If all OK, you need to reset the readings of Home unit by pressing button “+”.
Afterward, you can set the time according to the following steps :
Press “Set” button and hold 3 seconds to enter TIME SETTING mode
To adjust the time by pressing "+” or “-" buttons (You can hold the button for fast
advance/fast backward)
Setting sequence: 12/24 hr -> year -> month -> day -> hour -> minute -> press
“set” to confirm within a few seconds.
(7) Mode & units for Rainfall :
(a) Mode for “per week”/ “per month”/ ”accumulated rainfall”
Press “-“ button for selection
(b) Mode for units (mm/ inch)
Press and hold “-“ button for 3 seconds to select the units (mm/ inch)
(8) Changing Battery of Rain Gauge & Home unit
If you find the reception of the signal
(1) Rain Gauge :
If the unit is out of power, please first cancel the registration of Home unit before
changing battery (follow the procedure (4b) mentioned in above), which is to make
sure the rain gauge can be registered after changing battery. Then you can start to
change the battery for the rain gauge.
(2) Home Unit :
Change the battery and then follow the steps (3) in the beginning for setting and
registration.
Technical Specification
Daily : 0mm - 999mm (0 inch - 39.33 inch)
Weekly & Monthly : 0mm - 9999mm (0 inch - 393.66 inch)
Resolution : 1mm /0.04 inch
Transmission range : 30m (open area)
Battery operated : 2pcs AAA for Home unit
2pcs AA for Rain Gauge
FCC DISCLAIMER
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.