User's Manual

The Wind Direction is indicated by the arrow pointer icons surrounding the Wind Speed reading.
The receiver displays 16 wind directions. Eight of the wind directions are marked on the display:
N for north, S for south, SW for Southwest, etc. If the wind direction is between North and
Northwest, for example, the arrow will point to the dot between the two directions.
The Wind Speed appears in the center of the arrow icons. The Wind Speed can display in miles
per hour (mph), kilometers per hour (km/h), meters per second (m/s), knots, or Beaufort (bft).
Press the “UNIT” button on the front of the receiver unit to change the display units.
The Wind Gauge Sensor measures both an average wind speed and the greatest wind speed, or
wind gust. The Average Wind Speed reported is an average of wind speed over the last 2
minutes. The Wind Gust reported is the maximum wind speed that occurred in the last 10 minutes.
Press the “WIND” button on the front of the receiver unit to switch between Average (“AVG”) and
Wind Gust (“GUST”) displays.
MAXIMUM / MINIMUM MEMORY
Press the “MEMORY” button on the front of the home receiver repeatedly to view the maximum &
minimum values of temperature, humidity, heat index or wind speed readings. To clear the
memory record, press and hold the “MEMORY” button while the respective values are displayed
onscreen.
TEMPERATURE & HUMIDITY TREND INDICATORS
One of 3 Trend Indicator arrow icons display near the temperature and the humidity displays.
• indicates Rising Temperature or Humidity readings if the change is more than 1 degrees
in an hour
• indicates Steady Temperature or Humidity readings
• indicates Falling Temperatures or Humidity readings if the change it is more than 1
degrees in an hour.
BACKLIGHT
Press the “BACKLIGHT” button for an extended green backlight to illuminate the receiver’s LCD
screen for easy viewing.
LOW BATTERY WARNING
When the batteries on the receiver unit or the remote unit are low, the Low Battery Indicator
(“ ”) icon will light up on receiver unit. If the batteries for the indoor receiver are low, the
Battery Icon near the indoor temperature display will light up. If the batteries for the remote Wind
Gauge Sensor are low, the Battery Icon near the Ch 1 indicator will light up. If there are 1 or 2
additional temperature/humidity sensors in use, a Battery Icon appearing near “Ch 2” or “Ch 3”
indicates the batteries in that remote sensor are low.
Please Note: Wind direction calibration is required before battery replacement in the Wind Gauge
Sensor. See the section on “Calibrating the Wind Gauge Sensor”.
Trouble-Shooting
Disconnected Signals
• If the receiver unit does not receive a transmission from a remote unit channel for 10 minute,
the display will show dashes. To correct this problem:
1. Go to the remote location of that channel to check that the unit is properly positioned, within the
appropriate transmission range.
2. If new batteries are faulty on the initial installation, install fresh batteries. If you did not notice
the Low Battery icon warning and the product performed correctly after initial set up, the batteries
have lost their charge. Replace batteries (see the Power Sources section of this manual.)