User's Manual
3. Check to make sure the transmission path is clear of obstacles and interference.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
--Consult the dealer or experienced ratio/TV technician for help.
Modifications not authorized by the manufacturer may void user’s authority to operate this device.
For Wind sensor
FCC ID is L5CW132TX-2 (transmitter)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Transmission Collision
Signals from other household devices, such as doorbells, home security systems and entry
controls, may interfere. This is normal and does not affect the general performance of this product.
The transmission will resume once the interference recedes.
Precautions
This Wireless Wind Gauge & Thermometer is engineered to give you years of satisfactory service
if you handle it carefully, following these guidelines:
1. The home receiver is intended for indoor use only. It is not sealed against moisture and could
be damaged if used outdoors.
2. Do not immerse the receiver in water. If you spill liquid on it, dry immediately with a soft, lint-
free cloth.
3. The Wind Gauge Sensor is weather-resistant but not waterproof. Do not immerse it in water or
allow snow to accumulate on it. If this accidentally occurs, dry it immediately with a soft, lint-free
cloth.
4. Though the Wind Gauge Sensor is weather-resistant, it should not be left outdoors in snow,
hail, heavy rainfall, extremely high wind conditions, or at temperatures at or below -4°F (-20°C). If
these conditions become likely to occur, temporarily move the transmitter to an indoor area.
Otherwise, permanent damage to the sensor’s internal circuits or external wind vane may occur.
5. Do not mount the remote sensor on a metal surface.
6. Do not subject the remote sensor to extremely severe temperatures.
7. Do not clean either unit with abrasive or corrosive materials. This may scratch plastic parts and
corrode electronic circuits.
8. Do not subject either unit to excessive force, shock, dust, temperature or humidity. This may
result in malfunction, shorter electronic life span, damaged battery or distorted parts.
9. Do not tamper with either unit's internal components. Doing so will invalidate the warranty on
this product and may cause damage. The unit contains no user-serviceable parts.